Inground Pool Winterizing Checklist: Week-by-Week Closing Steps
Close by water temperature and freeze forecast, not a calendar date, then work backward through six weeks of tasks.
Save to PinterestWe may earn a commission when you buy through links on this page. It never changes what we recommend. Learn more
The short answer
Close an inground pool when the water stays below about 65°F and before the first hard freeze. Start four to six weeks ahead: balance the water, clean, shock, lower the level, drain the equipment, blow out and treat the lines, then cover. Pools in warm climates usually stay open with the pump running.
- Typical cost
- About $40 to $100 for a winterizing chemical kit and supplies; roughly $250 to $700 if a pro closes it
- Time needed
- About 3 to 5 hours of hands-on work, spread over four to six weeks
- Skill level
- Intermediate
Key points
- Close when water temperature holds below roughly 65°F, and finish before the first forecast night at or below 32°F.
- Balance the water and clean the pool two to three weeks before closing, because a dirty pool under a cover can grow algae all winter.
- Lower the water to the level your cover maker specifies; solid covers generally need less lowering than mesh safety covers.
- Blow out the plumbing lines and plug them before adding pool antifreeze, and never use automotive antifreeze.
- Warm-climate pools should keep circulating, hold free chlorine at about 1 to 3 ppm, and run the pump through any freeze warning.
In this guide
- When should you close an inground pool?
- What should you do four to six weeks before closing?
- How low should you lower the pool water for winter?
- How do you blow out and protect the plumbing lines?
- What should you do in the final week, and what can you skip?
- What about warm-climate pools that stay open?
- When should you hire a pool pro to close the pool?
Water temperature, not the calendar, tells you when to close an inground pool: once it holds below about 65°F, algae slows and the pool is ready. In cold-winter states that often means mid-October to mid-November, but a warm September or an early cold snap can shift it by weeks. This pool winterizing checklist works backward from that point.
When should you close an inground pool?
Close the pool when the water temperature stays below roughly 65°F and before your first hard freeze, meaning a night at or below 32°F. Watch the forecast, not the date.
Closing too early is the common mistake. Water in the 70s is still warm enough for algae to bloom under a cover, and you'll open a green pool in spring. Closing too late risks a freeze that cracks a pump housing, a heater, or a buried line before you've drained anything.
Start the checklist when overnight lows begin to touch the 40s, then pick a closing day once the water has stayed under 65°F for several days running.
| Timing | Main task | Why |
|---|---|---|
| 4 to 6 weeks out | Gather supplies, test and balance water | Balanced water protects the surface and lets chemicals work |
| 3 weeks out | Deep clean, brush, vacuum, clear baskets, service the filter | Debris feeds algae and stains under the cover |
| Final week | Shock, add winterizing chemicals per the kit label | Clean, sanitized water stays clearer through winter |
| Closing day | Lower water, drain equipment, blow out lines, plug, antifreeze, cover | Lines and equipment must be empty or protected before freezing |
| After closing | Check the cover after storms, pump off water, look monthly | Standing water and wind damage grow quietly |
What should you do four to six weeks before closing?
Buy a winterizing chemical kit, a test kit with fresh reagents, and your plugs, then start bringing the chemistry into range. Early work leaves time to fix problems instead of closing over them.
Common targets are pH of 7.2 to 7.6, total alkalinity of 80 to 120 ppm, and calcium hardness somewhere between roughly 150 and 400 ppm, depending on whether you have vinyl, fiberglass, or plaster. Check your surface manufacturer's numbers if you have them. Low calcium can etch plaster, and high pH invites scale. Neither fixes itself over winter.
Three weeks out, clean hard. Skim, brush the walls and steps, vacuum, and empty the skimmer and pump baskets. Run the filter continuously for a couple of days afterward. Remove and rinse a cartridge filter; backwash a sand or DE filter, and recharge DE per the manufacturer.
How low should you lower the pool water for winter?
Lower the water about 4 to 6 inches below the skimmer opening for a solid cover, and often 12 to 18 inches below the coping or tile line for a mesh safety cover. Your cover manufacturer's number overrides any general advice.
Use a submersible pump or set the filter to waste. Don't drain the pool further. An empty or half-empty inground pool can float or heave when groundwater is high, and a vinyl liner can shrink and tear without water behind it. If you think the pool needs draining for repairs, talk to a pool pro first.
Once the level is down, drain the equipment. Open the pump drain plugs, drain the filter and heater, empty the chlorinator or salt cell housing, and remove pressure gauges. Store the plugs inside the pump basket so you can find them in April. Set a multiport valve to the winter position, per the manual.
How do you blow out and protect the plumbing lines?
Push compressed air through each line with a blower or shop vac until only air bubbles out, then plug the line at the pool while the air is still running. That keeps water from creeping back in.
Start at the equipment pad. Attach the blower to the suction side and work through the skimmer line and any main drain, then repeat on the return side. Thread plugs into the returns. At the skimmer, use a plug on the line or set a gizzmo in the skimmer body. Lines running to a spa, waterfall, or water feature need their own pass.
Then add pool antifreeze, a propylene glycol product made for this job, to lines that may still hold a little water. Never use automotive antifreeze. Ethylene glycol is toxic and doesn't belong near a pool. Antifreeze is a backup to blowing the lines out, not a substitute.
What should you do in the final week, and what can you skip?
In the final week, shock the water, add the winterizing chemicals, and secure the winter cover. Skip anything that doesn't protect the pool from freezing or algae.
Shock a day or two before covering, then follow your kit's directions for algaecide and any stain or scale products. Overdosing wastes money and can bleach a liner. Don't cover a dirty pool, and don't toss in floating dispensers you won't check.
Fit the pool winter cover snugly. Water bags or anchors hold a solid cover down; a mesh safety cover uses straps and deck anchors. Add a cover pump to a solid cover so rain and snowmelt don't collect on top. Standing water on a cover is a drowning risk for children and animals, and a safety cover only protects anyone if it's installed and tensioned correctly. Barrier and cover requirements can vary by town, so check local code. The Pool Safely campaign from the U.S. Consumer Product Safety Commission offers guidance on pool barriers and safety.
Do a final check after the first storm. Wind lifts covers, and a gap lets leaves in.
What about warm-climate pools that stay open?
In a warm climate, keep the pool open and run it, because a stagnant pool breeds algae even in mild winters. The job shifts to a lighter cool-season routine rather than a shutdown.
Keep free chlorine at about 1 to 3 ppm and test weekly. Algae slows as water cools, but a sunny January week can restart it. Run the pump fewer hours than in summer, often 6 to 8, and brush the walls every week or two. Leaves keep falling, so keep emptying the skimmer basket.
The real danger is the occasional freeze. When the forecast shows a low near 32°F, run the pump all night so moving water keeps the lines from freezing, and confirm that any freeze-protection sensor on your automation works. If a hard multi-day freeze is possible, treat the equipment like a cold-climate pool and drain it.
Heaters behave differently in cool weather, too. A heat pump loses output as air temperature drops, so check its rated operating range before you plan on swimming in January.
When should you hire a pool pro to close the pool?
Hire a pro if you can't blow out the lines confidently, your pool has a spa or water feature with complex plumbing, or you've had freeze damage before. Typical U.S. closing prices run about $250 to $700, depending on pool size, region, and extras.
A pro also makes sense with an automatic cover, a heater with unusual drain steps, or underground lines you can't trace. Ask whether the price includes chemicals, antifreeze, and a spring-opening visit, since those vary by company.
Your next step: put today's water temperature and the 10-day forecast on your phone, buy the winterizing kit, and test the water this weekend.
Questions people ask
What if a freeze hits before I've closed the pool?
Run the pump continuously through the freeze so moving water protects the lines, and drain the equipment as soon as you can. Don't wait for the water to hit 65°F if a hard, multi-day freeze is forecast.
Do I need to add antifreeze if I blow out the lines?
Pool antifreeze is a backup, not a replacement for blowing out the lines. It protects spots where a small amount of water might remain, and it must be propylene glycol made for pools. Some pros skip it in mild regions, but it's cheap insurance where hard freezes happen.
Should I leave the pump running all winter?
In a cold climate, no. Drain the equipment and turn the pump off at the breaker. In a warm climate, run it daily at reduced hours and overnight during any freeze warning.
What if there's ice on the pool cover?
Ice on a cover is common, but don't chip at it or walk on it. Pump off meltwater and keep the cover pump clear. If the cover sags or tears, fix it before the next storm.
Does a saltwater pool close differently?
The steps are mostly the same. The salt cell usually needs to be removed, cleaned, and stored per the manufacturer's instructions, and your chemistry still needs to be balanced before closing.
Sources and further reading
- Pool Safely (CPSC) Pool barrier and cover safety guidance from the CPSC campaign
- Electrical Safety Foundation International Electrical safety information for outdoor and pool equipment
Was this article helpful?