Bring Garden Statues Inside for Winter? A Month-by-Month Plan
Hollow concrete and resin pieces fail first, and trapped water is why; here's when to move, raise, or cover each one.
Save to PinterestWe may earn a commission when you buy through links on this page. It never changes what we recommend. Learn more
The short answer
Yes, bring hollow concrete and resin statues inside if your winter has repeated freeze-thaw cycles and the piece is light enough to move safely. If it's too heavy, empty any water, raise it 1 to 2 inches off the ground, seal it, and cover it loosely. Solid, sealed stone can usually stay out. Warm climates need covers only for rare freezes.
- Typical cost
- $15 to $80 in supplies (sealer, patch, pot feet, breathable covers)
- Time needed
- One afternoon in fall, then 5-minute checks after storms and thaws
- Skill level
- Beginner
Key points
- Hollow concrete and hollow resin pieces are the most likely to crack because water gets inside and expands as it freezes.
- Do the cleaning, crack repair, and sealing in October while you still have several dry days in a row.
- Raising a statue 1 to 2 inches off the ground on pot feet or stone shims keeps it from wicking up moisture and freezing to the base.
- Use a breathable cover, never a tightly sealed plastic tarp, which traps condensation against the surface.
- Wait until nights stay above freezing for about a week before uncovering or resetting statues in spring.
In this guide
- Should I Bring Garden Statues Inside, Raise Them, or Leave Them Out?
- Why Do Garden Statues Crack in Winter?
- October Checklist: Clean, Dry, and Seal Before Temperatures Drop
- November Checklist: Empty Water, Lift Off the Ground, and Protect Joints
- December to February: How Do I Monitor Statues Through Freeze-Thaw Cycles?
- Cold-Climate vs Warm-Climate Differences in Winter Care
- March to April: Inspection and Reset After Winter
Start with the hollow concrete or resin statue that sits in wet soil, because it's the piece most likely to crack in a hard freeze. The cause is simple: water gets in, freezes, and expands with more force than thin walls can take.
Should I Bring Garden Statues Inside, Raise Them, or Leave Them Out?
Bring a statue inside if it's hollow, light enough to lift safely, and your yard freezes and thaws repeatedly in winter; raise and cover it if it's too heavy; leave it out only if it's solid, sealed, and sitting on a well-drained base.
- Bring in: hollow resin, thin-walled cast concrete, anything with a cupped surface that holds water, anything with fine detail like fingers or wings.
- Raise and cover: a heavy concrete garden statue you can't move without help, or one set in a bed you don't want to disturb.
- Leave out: dense, solid stone or well-cured solid concrete, sealed, on gravel or pavers. Our guide to frost-proof garden statue material covers which types qualify.
If you're unsure, move it. A dry garage or shed works fine, and it doesn't need heat.
Why Do Garden Statues Crack in Winter?
Statues crack because water absorbed into the surface or trapped in a hollow cavity expands by roughly 9 percent when it freezes, and the material can't give.
A hollow resin statue is a particular risk because a hairline seam or an open base lets rain in, and the water has nowhere to go. Concrete is porous, so it drinks moisture from the surface and from the soil below. One hard freeze may do nothing. Repeated freeze-thaw cycles, where the piece thaws by afternoon and refreezes overnight, widen small cracks a little each time. That's why a mild, swingy winter in Ohio can be harder on statuary than a steady, deep-cold one in northern Minnesota.
October Checklist: Clean, Dry, and Seal Before Temperatures Drop
October is the time to clean, repair, and seal, because sealer and patch material need dry weather and mild temperatures to cure. Check the product label for its minimum application temperature, which is often around 40 to 50°F.
- Clean it. Use a soft brush, water, and mild dish soap. Skip the pressure washer on older concrete, which can strip the surface and open pores.
- Let it dry for several days. Sealing damp concrete locks moisture in.
- Repair cracks. Fill hairline cracks in concrete with a masonry patch. For resin, use an exterior-rated epoxy or the manufacturer's repair kit.
- Apply masonry sealer to concrete. Pick a penetrating sealer that still breathes over a film-forming gloss coat, which can trap vapor and peel. A quart or gallon typically runs $20 to $70.
- Check the base of hollow pieces. Confirm any drain hole or open bottom isn't clogged with dirt or insects.
November Checklist: Empty Water, Lift Off the Ground, and Protect Joints
In November, your job is to get every drop of water out and get the statue off wet ground before the first hard freeze.
- Empty cupped surfaces. Bowls, open hands, and birdbath-style tops collect rain and ice.
- Raise it. Set heavier pieces on pot feet, flat stone shims, or pavers for a 1 to 2 inch air gap. That stops moisture wicking up and keeps the base from freezing to the ground.
- Separate stacked sections. Multi-piece statues can trap water between joints. Lift off the top, dry both surfaces, and wrap the joint area.
- Remove lights. Unplug the transformer first, then pull low-voltage fixtures and cords. If any wiring is hardwired, have a licensed electrician disconnect it. Our notes on low-voltage lighting for garden statues help if you're re-planning the setup.
- Cover loosely. A breathable cover such as burlap or a canvas drop cloth, tied at the base, sheds snow without trapping condensation. A clear plastic tarp pulled tight causes the very problem you're trying to avoid.
December to February: How Do I Monitor Statues Through Freeze-Thaw Cycles?
Check covered or raised statues after every major storm and every thaw, because those are the moments water collects and freezes again.
Brush off heavy snow with a soft broom. Don't chip at ice, which takes surface material with it. Keep de-icing salt away from statues and their bases, since salt works into the surface and speeds flaking. If a cover has blown loose, retie it. If you see standing water on an uncovered piece, wipe it off on a dry day.
Statues stored inside need only a monthly look. Make sure they're sitting on wood or foam, not directly on a damp concrete floor.
Cold-Climate vs Warm-Climate Differences in Winter Care
In cold climates you protect against months of freeze-thaw; in warm climates you protect against the occasional surprise freeze and the damp that comes with mild winters.
| Region | Typical approach | Main risk |
|---|---|---|
| Upper Midwest, Northeast | Bring hollow pieces in; raise and cover heavy ones; seal in October | Months of freeze-thaw cycling, ice buildup |
| Mid-Atlantic, Ohio Valley, Pacific Northwest | Same plan, but watch forecasts; covers matter more than storage for solid pieces | Frequent swings around 32°F plus cold rain |
| Gulf Coast, Florida, low desert Southwest | Leave most pieces out; keep covers ready for freeze warnings; empty water first | Rare hard freezes, mildew in humidity, wind tipping |
In warm regions, one rule covers most nights: if the forecast low is 32°F or below, empty any water from the statue and cover it that afternoon. Uncover it once temperatures climb back up so the surface can dry. If wind or a storm has shifted a piece, our guide on anchoring a garden statue so it doesn't tip or sink helps with the base.
Local conditions vary a lot. Your county extension office can give you average first and last frost dates for your area.
March to April: Inspection and Reset After Winter
Do the spring check once nighttime lows have stayed above freezing for about a week, which often means late March or April in cold regions and earlier in the South.
Uncover each statue and look closely for new cracks, flaking, chipped details, and separated joints. Then test the sealer on concrete by sprinkling water on it. If it beads, you're fine. If it soaks in within a minute, plan to reseal.
Frost heave shifts pavers and soil, so re-set the statue on firm, level ground or a gravel pad. Patch hairline cracks now, before spring rain gets in.
This week, tip one hollow statue gently and listen for sloshing. If you hear water, tilt it to drain and get it somewhere dry before the first freeze warning hits.
Questions people ask
Can concrete garden statues stay outside all winter?
Solid, well-cured concrete that's been sealed and raised off wet ground often handles winter fine, especially in mild climates. Hollow or thin-walled pieces are riskier and are better stored inside where freezes repeat.
Should I wrap a statue in bubble wrap or blankets?
Indoors, a moving blanket or similar fabric is fine for protecting the surface. Outdoors, avoid anything that seals against the statue, because trapped moisture can freeze on the surface.
Should I drill a drain hole in a hollow statue?
Only if the manufacturer allows it. Drilling can crack thin concrete or weaken resin, so first check for an existing opening in the base and keep it clear.
Do I need to seal resin statues like concrete ones?
Resin isn't porous like concrete, so a penetrating masonry sealer isn't the right tool. Focus on checking seams, repairing cracks with exterior-rated epoxy, and keeping water out of the cavity.
Do I need to move statues before the first light frost?
Usually not, if the piece is dry and the frost is brief. Plan to move or protect statues before a stretch of hard freezes, and sooner if rain is forecast just ahead of a cold snap.
Sources and further reading
- U.S. Consumer Product Safety Commission General consumer product safety information from the federal agency
- Electrical Safety Foundation International Electrical safety guidance, useful if you power statue lighting
Was this article helpful?