Fix and Furrow
Advertise

Part of our Home Repair Troubleshooting guide

Condensation on Windows in Winter: Causes, Checks, Fixes

A hygrometer, a humidity target by outdoor temperature, and a checklist of culprits, from humidifier settings to failed glass seals.

Save to Pinterest

We may earn a commission when you buy through links on this page. It never changes what we recommend. Learn more

Condensation droplets on the inside of a double-pane window on a cold winter morning
Photo: Randy Laybourne on Unsplash

The short answer

Condensation on the inside of your windows means indoor humidity is too high for how cold the glass is. Measure with a hygrometer, then hold humidity near 30 to 40 percent when it's around 20°F outside, and lower as it gets colder. Common culprits are an overset humidifier, weak bath fans, and laundry dried indoors. Fog between the panes means a failed seal.

Typical cost
$0 to $100 for most fixes; $200 to $1,500 per window if a seal has failed
Time needed
One afternoon to diagnose, 2 to 3 days to see results
Skill level
Beginner

Key points

  • Wipe the wet glass with a dry towel first: water that wipes off the room side is a humidity problem, fog between the panes is a failed seal.
  • A digital hygrometer, typically $10 to $25, tells you your real indoor humidity, and the target drops as outdoor temperatures fall.
  • A furnace humidifier set too high is the first thing to rule out, followed by bath fans that don't exhaust outdoors.
  • Damp crawlspaces and disconnected dryer vents can quietly push moisture into the house all winter.
  • Fogged double-pane units are fixed by replacing the glass unit or the window, not by lowering humidity.
In this guide
  1. Is the condensation inside, outside, or between the panes?
  2. What indoor humidity should I aim for, and how do I measure it?
  3. Is my humidifier set too high?
  4. Are my bath and kitchen fans actually clearing moisture?
  5. What other daily habits add moisture to the air?
  6. Could crawlspace or basement moisture be the cause?
  7. Does fog between the glass mean a failed double-pane seal?
  8. When should I call a pro?

Wipe a wet window with a dry towel and see whether the water comes off. Moisture on the room side or the outside wipes away; fog between the panes doesn't. That ten-second check tells you whether you're fighting indoor humidity or a failed seal, and it can keep you from buying a dehumidifier you don't need.

Is the condensation inside, outside, or between the panes?

Only the room-side kind is a humidity problem: water on the inside of the glass means indoor humidity is too high for how cold the window surface is. Moisture on the outside of the glass on a clear, cool morning can be normal, and it often shows up on well-insulated windows. Fog or droplets trapped between the panes point to a failed seal, covered near the end.

Don't shrug off the inside kind. Water pooling on sills can rot wood and feed mold, usually as black specks along the bottom of the sash or in the corners.

What indoor humidity should I aim for, and how do I measure it?

Aim for roughly 30 to 40 percent relative humidity in cold weather, and go lower as outdoor temperatures drop. Buy a digital hygrometer, which typically runs $10 to $25, and set it at chest height in the room with the worst windows, away from vents and the kitchen. Give it 30 minutes, then check a couple of other rooms.

EPA guidance suggests keeping indoor humidity between about 30 and 50 percent, and below 60 percent at the very most to discourage mold. Winter windows usually need the low end of that range. Treat the table as a starting point, since glass type and frame material change the result:

Outdoor temperatureTarget indoor humidity
40°F and above40 to 50 percent
20°F to 40°F35 to 40 percent
0°F to 20°F30 to 35 percent
Below 0°F20 to 30 percent

Single-pane glass and older aluminum frames sweat at lower humidity than newer double-pane windows, so sit at the low end of each band. If you're already at target and the glass still runs wet, the windows themselves are the weak point. Interior window film or storm windows are a cheaper fix than replacement.

Is my humidifier set too high?

It might be, and a furnace humidifier set too high is one of the most common causes of wet windows. It's easy to dial it to 45 percent in October and forget it, which is far too much once nights hit the teens. Turn the humidistat down to 30 to 35 percent for typical January weather.

If your unit has an automatic mode that reads an outdoor sensor, don't assume it's working. Compare its setting to your hygrometer. To confirm the humidifier is the source, turn it off for two to three days and watch the readings and the glass. Portable console humidifiers follow the same logic: use the humidistat, not the highest setting.

Are my bath and kitchen fans actually clearing moisture?

Not always: a bath fan that's undersized, clogged, or ducted into the attic leaves a shower's worth of vapor in the house. Hold a single square of toilet paper against the grille with the fan running. If it doesn't stick, the fan is weak or the duct is blocked.

Then look in the attic. The duct should run to a roof or wall cap outdoors, not end loose in the insulation. A common rule of thumb for smaller bathrooms is about 1 cubic foot per minute per square foot of floor area, and the fan should run roughly 20 minutes after you finish showering. A timer switch or humidity-sensing switch makes that automatic. Shut off the breaker before touching fan wiring, and bring in an electrician for new wiring or a roofer if the fix means a new roof cap.

Kitchens work the same way. A range hood that vents outside removes cooking steam. A recirculating hood only filters grease and sends the water vapor back into the room.

What other daily habits add moisture to the air?

Drying laundry indoors and running a leaky dryer setup are the biggest habits after showers. A drying rack loaded with wet towels releases all that water into the room as it dries. Put it near a running exhaust fan, or use the dryer.

Check the dryer vent too. The duct should run outdoors, be firmly connected, and be free of lint. Use rigid or semi-rigid metal duct rather than foil or vinyl, which sag and trap lint, and a crushed or disconnected run dumps moisture and heat into the laundry room. Large houseplant collections, uncovered aquariums, and boiling pots without the hood on add smaller amounts.

Could crawlspace or basement moisture be the cause?

Yes, damp ground under the house can push moisture up through the floor all winter. Signs include a musty smell, higher hygrometer readings on the lowest level than upstairs, and condensation that's worst on ground-floor windows.

In a dirt crawlspace, a crawlspace vapor barrier of at least 6-mil polyethylene, overlapped at the seams and sealed up the walls, cuts ground moisture a lot. Many installers prefer thicker sheeting, and local code may specify the material. Wear a respirator and gloves if you go in, and stay out if you see standing water or heavy mold. Also check that gutters discharge several feet from the foundation and that the soil slopes away from the house. In a basement, a dehumidifier set to 40 to 50 percent can help while you sort out drainage. Full encapsulation costs more, and our crawl space insulation cost guide breaks down the ranges.

If you've fixed every source and the house is still too humid, it may simply be tight. A mechanical ventilator can bring in drier outdoor air in cold weather, and an HVAC contractor should size it. Our HRV installation cost guide covers what that runs.

Does fog between the glass mean a failed double-pane seal?

Yes. Haze, droplets, or mineral streaks between the panes mean the seal around the insulated glass unit has failed and humid air got in. Lowering your indoor humidity won't clear it.

The fix is usually replacing the glass unit in the existing frame, which often runs $200 to $600 per window depending on size and glass type. Replacing the entire window commonly costs $500 to $1,500 installed. Check the warranty first, since many manufacturers cover seal failure for a set number of years, often 10 to 20. A failed seal also cuts the window's insulating value, so don't ignore it for years.

When should I call a pro?

Call one when the cause isn't something you can see or fix with a dial. Specifically:

  • Mold covering more than about 10 square feet, or mold that returns after you clean it and cut humidity.
  • Soft, stained, or rotting wood around the window frame or wall.
  • Standing water or a strong musty smell in the crawlspace.
  • Humidity above 50 percent in deep cold after you've tried every fix above.
  • Any suspicion of unvented combustion or carbon monoxide.

For everything else, start today: buy a hygrometer, drop the humidifier to 30 to 35 percent, run the bath fans longer, and recheck the windows in 48 hours.

Questions people ask

Why are my windows dripping in winter even though I don't use a humidifier?

Everyday living adds a lot of moisture through showers, cooking, laundry, and breathing, and a tightly sealed house traps it. Start with a hygrometer reading and check that your bath fan and dryer vent exhaust outdoors. A damp crawlspace or basement can add more.

Is window condensation a sign of mold in my house?

Not by itself, but constant moisture is what mold needs. If you see black or green growth on the sill or frame, clean it with detergent and water, fix the humidity, and watch for it coming back. Growth over a large area is a job for a professional.

Will a dehumidifier stop condensation on windows?

It can, if indoor humidity is the cause and the unit is sized for the space. Set it to hold around 30 to 40 percent in winter and empty or drain it regularly. If the real source is an overset humidifier or a weak fan, fix that first.

Do curtains and blinds make window condensation worse?

They can. Heavy closed curtains keep warm room air away from the glass, so the surface stays colder and collects more moisture. Opening them for part of the day or moving air across the window with a small fan helps.

Does condensation mean I need new windows?

Usually not. Moisture on the room side is normally a humidity issue you can control. New windows make sense when you have failed seals, rot, or drafty frames, or when single-pane glass stays wet even at low humidity.

Sources and further reading

Elsewhere in Heating, Air & Water