Indoor Air Quality Checklist by Month, October to March
Humidifier pads, dryer vents, and CO alarms each have a best month, and your climate shifts the dates.
Save to PinterestWe may earn a commission when you buy through links on this page. It never changes what we recommend. Learn more
The short answer
Start in October by servicing the humidifier, swapping the furnace filter, and booking a tune-up. Test carbon monoxide alarms in November, clean the dryer vent by early December, hold indoor humidity near 30 to 50 percent in January and February, and shut the humidifier down in March. Humid Southeast homes can skip most humidifier steps; dry Mountain West homes need them most.
- Typical cost
- $40 to $120 in DIY supplies; $100 to $250 per pro tune-up or vent cleaning visit
- Time needed
- One to three hours per month
- Skill level
- Beginner
Key points
- Service the humidifier and replace the pad in October, before the first sustained heating run, not after the dry air arrives.
- Test every carbon monoxide alarm in November and check its replacement date, since heating appliances now run daily with windows shut.
- Clean the dryer vent by early December, before the house is fully sealed and laundry loads grow.
- Aim for roughly 30 to 50 percent indoor humidity, and drop toward the low end in deep cold to avoid window condensation.
- Climate changes the plan: humid Southeast homes focus on dehumidifying, Mountain West homes on humidifying, and mixed climates on switching between the two.
In this guide
- Why Start in October?
- October: Pre-Season Walkthrough and Humidifier Service
- November: Combustion Safety and CO Alarm Checks
- December: Dryer Vent and Exhaust Cleaning
- January to February: Humidity Targets and Mid-Winter Checks
- March: Shutdown and Spring Prep
- How Your Climate Changes the Schedule
- When to Call a Pro Instead of DIY
Service the humidifier and look over the furnace area before the first stretch of cold weather. That's when the house seals up, and whatever is sitting in the pad, the ductwork, or the dryer vent starts circulating. Each job below is timed just before the condition that makes it matter.
Why Start in October?
October is the right start because you can still open windows, test equipment without pressure, and book a technician before the first cold snap fills their calendar. Most winter air problems come from a closed house plus gear nobody checked: a crusted pad, a lint-packed vent, an alarm with a dead battery.
| Month | Main tasks | Why then |
|---|---|---|
| October | Humidifier service, furnace filter, walkthrough, book tune-up | Before the first sustained heating run |
| November | CO alarm tests, combustion appliance look, chimney check | Heat runs daily with windows shut |
| December | Dryer vent and exhaust fan cleaning | House is closed up, laundry loads grow |
| January to February | Hygrometer readings, pad and filter checks | Coldest, driest stretch |
| March | Humidifier shutdown, AC tune-up booking, ventilate | Heating winds down |
October: Pre-Season Walkthrough and Humidifier Service
In October, service the humidifier before it runs for the first time and do a quick walkthrough of everything that moves air. The common type is a whole-house humidifier with an evaporative water panel, the humidifier pad, which collects minerals all season. A new pad typically runs $10 to $30. We'd replace it every October no matter how it looks, because a fresh pad is cheap and a crusted one does a poor job. Turn off the water supply and the unit's power, set the humidistat to off, pull the old pad, scrub the tray, check the drain line, and install the new one. Then restore water and power, set the humidistat, and run it.
Portable units need the same attention. Empty them, descale per the manufacturer's directions, and use distilled water in ultrasonic models so mineral dust doesn't get blown into the room. Skip homemade bleach mixes unless the manual calls for them.
Swap the furnace filter too. Don't jump to a thicker or higher-MERV filter unless the furnace manual allows it, because restricted airflow strains the blower and can hurt heating performance.
Book your pre-season tune-up now if you haven't. A furnace visit typically costs $100 to $250, and early fall slots go fast.
November: Combustion Safety and CO Alarm Checks
Test every carbon monoxide alarm in November, once the furnace and water heater are running daily. You want one on each level and near sleeping areas. Press the test button, then read the date on the back. Alarms have a limited life, often 5 to 10 years depending on the model, and a unit past its date should be replaced even if it still chirps on test. A new alarm usually costs $20 to $60.
Then look at the appliances themselves. Where you can see a burner flame, it should be steady and blue. Check around the water heater and furnace flue for rust streaks, soot, or loose pipe joints, and keep storage clear so combustion air isn't blocked. If you burn wood, have a certified chimney sweep inspect the chimney before heavy use.
December: Dryer Vent and Exhaust Cleaning
Clean the dryer vent by early December, before the house is fully sealed and holiday laundry piles up. Lint buildup is a fire hazard, and a clogged duct can leak warm, damp air into the room. Unplug the dryer, pull it out, and disconnect the duct. Run a dryer vent brush kit from both ends, vacuum the lint, and confirm the outside flap swings open freely with no nest behind it. Replace white vinyl or plastic accordion duct with rigid or semi-rigid metal.
A sign it's overdue: towels need two cycles to dry. Professional dryer vent cleaning typically costs $100 to $200, and it's worth paying for on long runs or roof exits. If your dryer is gas, pulling it out risks the gas connection, so leave that to a pro.
Vacuum the grilles on kitchen and bath exhaust fans while you're there, and confirm they still hold a tissue against the cover. These fans are your main moisture exit in a closed house.
January to February: Humidity Targets and Mid-Winter Checks
In January and February, aim for indoor relative humidity between about 30 and 50 percent, in line with EPA's general guidance, and lean toward the low end in deep cold. Buy a digital hygrometer for $10 to $20 and place it in a main living area, away from the humidifier. If windows fog or drip, the target is too high for your glass and insulation. Drop the setting a few points until the condensation stops.
Check the humidifier pad monthly for white crust, and the furnace filter every month or two while the system runs nearly nonstop. Wipe any mineral film off the tray. Keep bath and kitchen fans running during and after steamy activities.
March: Shutdown and Spring Prep
March is when you shut the humidifier down, because stagnant water in an idle unit grows slime and smells. Turn off the water, set the humidistat to off, drain the tray, and let it dry. Some models have a bypass damper to close, so check the manual. Toss the used pad and put a fresh one in next October.
Replace the furnace filter, then book your AC tune-up before the spring rush. Open windows on mild days to flush stale air, but go easy on high-pollen days if allergies are an issue. Check basement corners for damp spots as thawing begins.
How Your Climate Changes the Schedule
Climate changes the schedule mainly by shifting when you humidify, when you dehumidify, and how often you check the pad. Use the table as a starting point and adjust to your hygrometer.
| Region | October | November to February | March |
|---|---|---|---|
| Humid Southeast | AC often still running; check drain line and keep humidity under 50 percent | Humidifier rarely needed; focus on exhaust fans, CO checks, dryer vent | Book AC tune-up early |
| Dry Mountain West | Service humidifier now | Run it from November; check pad every few weeks, since hard water scales fast | Shut down later, sometimes April |
| Midwest and Northeast | Service humidifier, swap filter | Humidity swings; lower the setting as temperatures fall | Dry out unit, check basements for damp |
In the Southeast, the biggest risk is too much moisture, not too little. If your house reads above 50 percent in winter, run bath fans longer and consider a dehumidifier rather than a humidifier. The other two regions need the full routine. If you have a tight, newer house with persistent stale air or moisture, a heat recovery or energy recovery ventilator may be the better fix, and a licensed HVAC contractor should size and install it.
When to Call a Pro Instead of DIY
Call a licensed professional for anything involving gas lines, flues, heat exchangers, or a CO alarm that has actually sounded. Also call one for dryer vents with long or roof-exit runs, chimney inspections, and visible mold covering more than roughly 10 square feet, the point at which EPA's mold guidance suggests bringing in help. If you smell gas, leave the house and call the utility from outside. Local codes govern flue and venting repairs, so a permit may be required.
Your next step: this week, buy a humidifier pad and a hygrometer, put the alarm test on the calendar for November 1, and book the pre-season tune-up.
Questions people ask
Do I need a humidifier if I live in a humid climate?
Usually not. Homes in humid regions can stay above 40 percent even in winter. Buy a hygrometer first and only add humidity if readings stay below about 30 percent.
Can I descale a portable humidifier with vinegar?
Many manufacturers approve white vinegar for descaling portable units, but some prohibit it. Check the manual first, then rinse the tank and base thoroughly before refilling.
Can a dirty humidifier make me sick?
A neglected unit can spread mineral dust and microbial growth into the air. Cleaning it at season start, wiping the tray, and changing the pad on schedule keeps that risk low.
How often should I change the furnace filter in winter?
Check it monthly and replace it when it looks gray and clogged, commonly every one to three months depending on filter thickness, pets, and house dust. The filter label and furnace manual give the intended interval.
Is it worth paying for a pre-season furnace tune-up?
For most gas furnaces, yes. A technician checks the burners, flue, and heat exchanger, which are the parts that affect CO risk and which you can't judge yourself. It typically costs $100 to $250.
Sources and further reading
- EPA Indoor Air Quality EPA guidance on indoor humidity, combustion pollutants, and mold.
- U.S. Dept. of Energy, Energy Saver Federal tips on furnaces, filters, and home energy upkeep.
- ASHRAE Ventilation and thermal comfort standards from the HVAC industry body.
Was this article helpful?