Part of our Roofing and Exterior guide
House Wrap Under Siding Cost: When It Pays and When to Skip
The layer nobody sees decides whether water drains or soaks your wall, and re-siding is the cheapest moment to get it right.
Save to PinterestWe may earn a commission when you buy through links on this page. It never changes what we recommend. Learn more
The short answer
Yes, you almost certainly need a weather-resistant barrier behind new siding, and most codes require one. Standard house wrap typically adds $40 to $100 per square (100 square feet of wall) installed, or roughly $800 to $2,000 for 2,000 square feet of wall area. Skip it only if sound existing wrap stays in place or your local code exempts the structure.
- Typical cost
- Typically $0.40 to $1.75 per sq ft installed for wrap ($800 to $3,500 on 2,000 sq ft of wall area)
- Time needed
- Often one to three days for a typical house, usually during the re-side
- Skill level
- Intermediate
Key points
- Siding sheds water but doesn't seal against it, so a weather-resistant barrier behind it is required by most codes and is cheap insurance.
- Standard wrap typically adds about $40 to $100 per square, drainage wrap about $75 to $175, and rainscreen battens roughly $150 to $400 more on top of the wrap.
- New siding installed over old siding leaves no room for wrap behind it, so tear-off is usually the better call on a wall that never had one.
- Intact, well-lapped existing wrap is the main reasonable case for skipping new wrap.
- Ask for wrap as a separate line item, with seam tape and window flashing details spelled out in the quote.
In this guide
- What does house wrap do behind siding?
- What happens when siding goes on without it?
- Standard wrap vs. drainage wrap vs. rainscreen battens: which do you need?
- What does each option add to your quote?
- When can you reasonably skip house wrap?
- When is house wrap non-negotiable?
- What should you ask your installer before signing?
Re-siding is the cheapest moment you'll get to add a weather-resistant barrier, because the old siding is off and the scaffolding is already up. Standard house wrap typically adds $40 to $100 per square (100 square feet of wall) to a quote, or roughly $800 to $2,000 on 2,000 square feet of wall area. Skipping it saves that money once and can cost you a rotted wall later.
What does house wrap do behind siding?
House wrap is a thin sheet over the wall sheathing and under the siding that blocks liquid water while letting water vapor pass out of the wall. Siding sheds most rain but doesn't seal. Wind pushes water through lap joints, nail holes, and gaps around windows and doors, and the wrap lets that water run down and out at the bottom of the wall. With seam tape on every joint, it also slows air leakage, which is part of ENERGY STAR guidance for an efficient home envelope.
One term clears up most quote confusion. A weather-resistant barrier is the job; house wrap is one way to do it. Others include 15-pound asphalt felt, liquid-applied membranes, and sheathing panels with taped seams.
House wrap is required under vinyl siding in most places. Codes based on the International Residential Code call for a barrier behind exterior wall coverings, with exceptions that vary by jurisdiction. Vinyl is hung with loose laps and drainage slots, and it assumes something water-resistant sits behind it. Confirm local rules with your building department, or read the model code from the International Code Council.
What happens when siding goes on without it?
Water that gets behind siding with no barrier lands on bare sheathing and can rot it over time. Plywood and OSB swell and delaminate, and the framing behind them follows if the leak is steady.
You rarely see it happening. The clues are stains under windows, soft spots in trim, peeling paint on interior walls, and a musty smell near exterior walls. By then you have a carpentry problem, not a siding problem, and the patch-versus-full-re-side decision gets more expensive once sheathing is involved.
Standard wrap vs. drainage wrap vs. rainscreen battens: which do you need?
Standard wrap sheds water, drainage wrap sheds it faster, and rainscreen battens give the wall an air gap to drain and dry. Standard wrap is a flat sheet, lapped shingle-style, that relies on gravity and flashing. Drainage wrap has embossed channels or a textured face that leave small drainage paths behind the siding. Rainscreen battens are furring strips, commonly 3/4 inch thick, set vertically over the wrap to create a continuous air gap that drains and ventilates.
Battens pay off mainly in wet or humid climates and with absorbent materials like wood. They also change the depth at windows, doors, and trim, so the detailing has to be planned before the order goes in.
For most re-sides, we'd pick drainage wrap over standard wrap anywhere wind-driven rain is routine, such as the Gulf Coast, the Southeast, and the Pacific Northwest. The upgrade is modest per square and gives the wall a way to dry. Read the siding maker's installation instructions for wrap and gap rules first, since warranties can depend on them.
What does each option add to your quote?
Typical U.S. ranges put standard house wrap at about $40 to $100 per square installed, drainage wrap at about $75 to $175, and rainscreen battens at roughly $150 to $400 more on top of the wrap. Material alone is a small slice, often well under $0.50 per square foot. Labor, seam tape, and flashing make up the rest.
| Option | Installed, per sq ft | Per square (100 sq ft) | On 2,000 sq ft of wall |
|---|---|---|---|
| Standard house wrap, taped seams | $0.40 to $1.00 | $40 to $100 | $800 to $2,000 |
| Drainage wrap | $0.75 to $1.75 | $75 to $175 | $1,500 to $3,500 |
| Rainscreen battens added over wrap | $1.50 to $4.00 | $150 to $400 | $3,000 to $8,000 |
Treat these as rough. Local labor rates, wall height, the number of windows and corners, and any sheathing repair all move them. Wall area also isn't the same as floor area, so measure yours before comparing quotes. The cheapest time to add wrap is while the old siding is off and the crew is already on site.
When can you reasonably skip house wrap?
You can reasonably skip new wrap when a sound barrier is already on the wall and stays in place, or when your local code exempts the structure. That covers a few situations:
- Replacing a few damaged boards or one wall section where the existing wrap is intact. Patch any tears with the manufacturer's tape.
- Walls whose sheathing is a panel with its own integrated, taped barrier.
- Small detached structures such as a shed, where some jurisdictions relax the rule.
"Vinyl is waterproof" is not a reason to skip it. Vinyl sheds water, but the laps aren't sealed, and water behind it needs somewhere to go. Ask the building department before you accept a no-wrap quote.
When is house wrap non-negotiable?
House wrap is non-negotiable whenever the wall has no working barrier and you're about to cover it for decades. New siding installed directly over old siding leaves no barrier behind it, because old siding isn't one. Some crews add a thin sheet over the old layer, but wrap over uneven siding bunches up and makes window flashing hard to do right.
On a wall that never had wrap, which includes many older homes, we'd pick tear-off. It lets you inspect the sheathing, fix rot, and detail the windows properly. Price it as its own line item so you can compare quotes fairly.
Torn wrap is a smaller problem. Tape small tears with the manufacturer's tape, and replace large holes with a properly lapped section. Most wraps also have a limit on how long they can sit exposed before siding goes over them, so check the label if the house has been wrapped and waiting.
What should you ask your installer before signing?
Ask about the product, the seams, the flashing, the permit, and what rotted sheathing will cost. Those six questions separate a careful crew from one that treats the wrap as filler.
- Which product are you using, and is it approved as a weather-resistant barrier under our local code?
- Are seams lapped shingle-style and sealed with seam tape, and how will you handle window flashing at every opening?
- Is the wrap priced as a separate line item, and what would drainage wrap or rainscreen battens add?
- Is tear-off included, and what do you charge per sheet if you find rotted sheathing?
- Does the siding maker's warranty require a drainage gap?
- Who pulls the permit, and will the wrap be inspected before siding covers it?
Your next step: get three quotes with the wrap, tear-off, and flashing broken out, and call your building department once to confirm what it requires.
Questions people ask
Does house wrap add insulation value?
Not in any meaningful way. Wrap manages water and air, and its R-value is negligible. If you want more thermal performance, ask about rigid foam sheathing, which has its own installation and flashing rules.
Can I leave house wrap exposed over the winter?
Only within the manufacturer's stated exposure limit, which varies by product. Long exposure to sun and wind can degrade wrap and tear it loose. If siding will be delayed, check the label and plan to repair or replace damaged areas.
Does the brand of house wrap matter?
Less than the installation does. Several makers sell code-approved products, and a cheaper wrap that is lapped, taped, and flashed correctly will outperform a premium one installed sloppily. Match the product to your climate and siding.
Do I need a permit to re-side my house?
Many jurisdictions require one, and some inspect the barrier before siding goes on. Rules vary by city and county, so call your building department. A reputable contractor typically pulls the permit and includes it in the quote.
Can I install house wrap myself?
A confident DIYer can wrap a single-story wall, but the details are what count: shingle-style laps, taped seams, and flashed windows. Work above ladder height carries real fall risk, so consider hiring out the upper walls.
Sources and further reading
- International Code Council Model building codes that govern weather-resistant barriers behind siding
- EPA Lead (Renovation, Repair and Painting) Lead-safe rules for renovating homes built before 1978
- ENERGY STAR Air sealing and efficient home envelope guidance
Was this article helpful?