Fix and Furrow
Advertise

Window Treatments Winter Checklist: Cold vs. Warm Climates

Cord safety, condensation, radiator clearance and fading each get a task and a reason, timed differently for Minnesota and Arizona.

Save to Pinterest

We may earn a commission when you buy through links on this page. It never changes what we recommend. Learn more

Lined curtains and cellular shades on a frosty living room window in winter
Photo: Ariel Domenden on Unsplash

The short answer

Before heating season, check cord safety devices, clean everything, and keep curtains clear of radiators and vents. In cold climates, add lined drapes and open south-facing blinds on sunny winter days. In warm climates, keep sun control working year-round, because fading and heat matter more than warmth there. Repeat the inspection each spring.

Typical cost
$0 to $75 in supplies for most homes
Time needed
About 2 to 3 hours per season
Skill level
Beginner

Key points

  • Check cords and every tension device before the heating season keeps everyone indoors.
  • Cold glass pulls condensation onto fabric and wood, so leave a 1 to 2 inch gap and open treatments on frosty mornings.
  • Lined drapes and thermal curtains need clearance from radiators, baseboard heaters and floor vents.
  • Cold-climate homes do the heavy work in September and October; warm-climate homes can spread it from fall to late winter and keep sun control running all year.
  • Open south-facing treatments on sunny winter days and close them at dusk to use free heat and cut losses.
In this guide
  1. Why does seasonal window treatment care matter?
  2. Fall checklist: how do you prepare blinds and curtains for cold weather?
  3. Winter tasks: what do you do about condensation, drafts and cords?
  4. Spring checklist: what should you clean and inspect?
  5. Summer checklist: how do you handle heat and fading?
  6. How do cold and warm climates change the schedule?
  7. Quick reference: what do you do each month?

Start with the cords, not the dust. Before the heating season keeps everyone indoors, check every corded blind for loose loops, a missing tension device, and cords that can reach a crib, bed or couch. Everything else on this window treatments winter checklist is maintenance. That one is safety.

The rest follows the logic of the glass: cold glass collects moisture, sun fades fabric, and radiators bake linings. Timing shifts with climate, so the cold-north and warm-south differences are marked throughout.

Why does seasonal window treatment care matter?

Seasonal care matters because the window is the one spot where temperature, moisture and sunlight all hit your fabric and slats directly. A curtain pressed against single-pane glass on a subzero night lives a very different life than one in a south-facing room in July.

Condensation, heat and ultraviolet light cause most of the damage, and each has its own task and season. The U.S. Department of Energy's Energy Saver guidance treats window coverings as part of heating and cooling, so the same chores save energy as well as fabric.

Fall checklist: how do you prepare blinds and curtains for cold weather?

To prepare blinds for winter, inspect cords, clean everything, add heavier layers, and clear heat sources. In cold climates, finish by mid-October. In warm climates, you can stretch the same list through November.

  1. Inspect cords and safety devices. Look for frayed cords, loose cleats and cord loops hanging within reach. If you have cordless blinds, skip the cord check but confirm they still lift and hold.
  2. Clean before you close up. Vacuum curtains with a brush attachment on low suction. Dust slats with a microfiber cloth, and wipe faux wood blinds with mild soap and a damp cloth. Check care labels before washing anything lined.
  3. Hang winter layers. Swap sheers for lined drapes or thermal curtains, and make sure the curtain rod and its brackets can carry the added weight. Screw brackets into framing or use wall anchors rated for the load.
  4. Clear heat sources. Keep fabric clear of radiators, baseboard heaters and floor registers, and never let it drape over or rest on a heat source. Follow the heater's manual for exact clearance, since requirements vary.
  5. Test every operating mechanism. A shade that sticks in October will fail in January. If a roller shade drifts down, see our guide to fixing a roller shade that won't stay up.

Winter tasks: what do you do about condensation, drafts and cords?

Winter work is mostly moisture control: open treatments on cold mornings, leave a gap behind curtains, and hold indoor humidity at roughly 30 to 50 percent, lower during hard freezes.

Cold glass chills the air touching it, and that air drops its moisture right there. A curtain pressed against the pane soaks it up, and the damp fabric stays wet all day. You get mildew spots on drapes, swollen valances and warped real wood slats. Leave a 1 to 2 inch gap between fabric and glass, and open everything for an hour each morning. If glass stays wet even then, look at ventilation or a failed window seal.

Open blinds on sunny days, especially on south-facing windows, to let in free heat. Close them at dusk to slow heat loss through the glass, which is standard Department of Energy advice. Cellular shades are a good fit for this routine because their trapped air cells add insulation.

Recheck cords after any rearranging, such as moving a bed or holiday furniture near a window. The U.S. Consumer Product Safety Commission publishes safety information on corded window coverings.

Spring checklist: what should you clean and inspect?

In spring, wash or vacuum everything, look for moisture damage left by winter, and swap heavy drapes for lighter layers. Early April works in cold regions. Late February or March works in warm ones.

Check the bottom edges of curtains and the lower slats of blinds for mildew, brown spotting or warping. Wash cotton and polyester panels per the label, and send lined or silk drapes to a cleaner. If real wood blinds warped in a kitchen or bathroom, compare options in cellular shades vs faux wood blinds before replacing like for like.

Then check hardware. Tighten brackets, look for sagging in the rod, and confirm cleats are still screwed into solid framing.

Summer checklist: how do you handle heat and fading?

In summer, close treatments on sun-facing windows during the hottest hours and check for fading and heat stress. Energy Saver guidance recommends this kind of daytime shading to cut solar heat gain.

Direct sun fades dyed fabric and can yellow or warp cheap vinyl blinds. Blackout curtains or cellular shades with a light-colored outer face reflect more heat than dark ones. If a window bakes all afternoon, adhesive window film reduces both heat and UV; check the film maker's guidance and your window warranty first, since some glass types need specific products. ENERGY STAR's home efficiency pages are a good starting point for comparing window upgrades.

If the sun hits one side of a room harder, rotate panels once a season so the fading evens out.

How do cold and warm climates change the schedule?

Cold climates put the heavy work in September and October, while warm climates run sun control all year and save the big cleaning for fall or late winter. The same month can mean opposite tasks in Minnesota and Arizona.

TaskCold climate (Minnesota, Maine)Warm climate (Arizona, Florida)
Winter layersHang lined drapes by mid-OctoberOptional; use light layers on chilly desert nights
Condensation watchDaily, November to MarchMostly a humid-coast issue; check bathrooms
Sun controlOpen south windows on sunny daysKeep blinds working on south and west windows year-round
Deep cleaningEarly fall and mid-springLate fall and late winter
Fading checksJune to AugustEvery season

For most cold-climate homes, we'd pick cellular shades behind lined drapes. The shades handle nightly heat loss, and the drapes add a second layer on the coldest nights. In warm climates, prioritize light-colored blackout curtains or window film over extra insulation.

Quick reference: what do you do each month?

Each month's job depends on climate: cold regions front-load work in fall, while warm regions spread it out and keep sun control going. Treat the table as a starting point and shift it two to four weeks earlier or later depending on when your first frost and first 90-degree day usually arrive.

MonthsCold climateWarm climate
September to NovemberInspect cords, clean, hang lined drapes, clear radiatorsInspect cords, deep clean after cooling season
December to FebruaryOpen on sunny mornings, close at dusk, watch condensationOpen south windows on cool days; check humidity
March to MayWash, inspect for mildew, swap to light layersInstall window film, switch to heat-reflective layers
June to AugustClose sun-facing windows at midday, rotate panelsClose treatments in peak heat, check for fading

Your next step takes about ten minutes: go window to window this weekend, check each cord and tension device, and note which treatments touch glass or a heater.

Questions people ask

Can I wash lined curtains at home?

Only if the care label says so. Many lined drapes shrink or lose shape in a washing machine, and the lining may react differently than the face fabric. When in doubt, vacuum them regularly and send them to a dry cleaner as needed.

Do thermal curtains really help with heating costs?

They help, mostly on very cold nights and at windows with single-pane or older glass. Hung close to the glass with no gaps at the sides, they cut heat loss more than loose, short panels. They won't replace sealing a leaky window.

How do I stop mold on window blinds?

Keep the glass from staying wet by running bath and kitchen fans, opening treatments each morning, and holding indoor humidity near 30 to 50 percent. Wipe light mildew with mild soap and water and dry fully. If it keeps coming back, check for a leak or poor ventilation.

Should I take curtains down for the summer in a warm climate?

Usually no. Sun control matters most in warm climates, so keep a heat-blocking layer up on south and west windows and swap only the heavy winter layers for lighter ones.

Do cordless blinds need any winter checks?

Yes, but they're simple. Test that they raise, lower and hold position, and check brackets for looseness. Cold can make some mechanisms stick, so repair a sticky shade before it fails completely.

Sources and further reading

Elsewhere in Decorating