Fix and Furrow
Advertise

Part of our Roofing and Exterior guide

Solar Panels on an Old Roof: 5 Costly Mistakes to Avoid

A 25-year array on a roof with 7 years left means paying to remove and reinstall every panel. Here's how to avoid that bill.

Save to Pinterest

We may earn a commission when you buy through links on this page. It never changes what we recommend. Learn more

Rooftop solar panels installed on an aging asphalt shingle roof with visible shingle wear
Photo: Paragon Exterior on Unsplash

The short answer

The costliest mistake is installing solar on shingles with less than about 15 years left, because replacing the roof later means paying for a detach and reset, often roughly $2,000 to $6,000 on top of the new roof. Get an independent roof inspection first, replace the roof before panels if its life is short, and put reset terms in writing.

Typical cost
Roughly $2,000 to $6,000 for a typical detach and reset; $8,000 to $20,000 for an asphalt roof replacement
Time needed
1 to 3 days for a reset; 1 to 2 days for a roof tear-off, plus scheduling
Skill level
Hire a pro

Key points

  • Solar panels commonly carry 25-year warranties, so an asphalt roof with under roughly 15 years left usually should be replaced first.
  • A detach and reset often runs roughly $2,000 to $6,000 for a typical home system, and that comes before the roofing bill.
  • An installer's roof warranty usually covers only its own penetrations, not worn-out shingles or the cost of removing panels for a roofer.
  • Older framing and brittle shingles raise the odds of structural problems and cracked tabs, so ask for a rafter check and properly flashed mounts.
  • Put roof-replacement timing and reset pricing into the signed contract before any work starts.
In this guide
  1. How Much Roof Life Should You Have Left Before Going Solar?
  2. Does the Installer's Roof Warranty Cover Future Roof Work?
  3. Do Older Rafters and Framing Need a Check Before Solar?
  4. How Should Solar Mounts Be Flashed on Old Shingles?
  5. What Does a Solar Detach and Reset Cost?
  6. Should You Replace the Roof First or Install Solar First?

The most expensive mistake with solar on an older roof is bolting a 25-year array to shingles with 7 years left. Panels often outlast asphalt roofs. When the roof fails under them, someone has to remove every panel, replace the roof, and reinstall the system. That someone is you.

How Much Roof Life Should You Have Left Before Going Solar?

If an asphalt roof has less than about 15 years left, replace it before the panels go on. That's a rule of thumb, not a code, since condition matters as much as age, but panels commonly carry 25-year warranties and the roof underneath should be able to keep pace.

This mistake happens because the installer's site visit checks sun exposure, pitch, and usable space, not shingle life. Nobody is eager to raise a five-figure roof bill in the first sales meeting. So hire a roofer who isn't selling solar for an independent roof inspection. Find the install date, shingle type, and number of layers. Three-tab shingles often last 15 to 20 years and architectural shingles 20 to 30, though hot climates shorten both.

Look for granules piling up in gutters, curled or cupped tabs, cracked shingles, bald patches, and soft spots in the decking. Any of those means the roof is closer to the end than its age suggests.

We'd pick replacement first for any roof in the gray zone. A tear-off is simpler and cheaper when panels aren't in the way.

Does the Installer's Roof Warranty Cover Future Roof Work?

No. A solar installer's roof warranty typically covers leaks at its own penetrations for a set period, often 5 to 10 years, though terms vary by company.

It doesn't cover shingles wearing out, and it doesn't pay to remove panels so a roofer can tear off the old roof. Many homeowners learn that only when a roofer quotes the job and says the panels have to come off first.

Before signing, get answers to these in writing:

  • What does the workmanship warranty cover, and for how many years?
  • Does it transfer if you sell the house?
  • Who pays to remove and reinstall panels if the roof needs replacement?
  • Does hiring your own roofer void anything?

Do Older Rafters and Framing Need a Check Before Solar?

Yes. Older roofs can have undersized rafters, sagging spans, or extra shingle layers, and panels add weight (typically a few pounds per square foot) plus concentrated loads where each mount attaches.

Older homes may have 2x4 rafters at wide spacing, plank decking, or years of hidden moisture damage. From the attic, look for sagging rafters, dark stains, or daylight where it shouldn't be. Count the shingle layers on top, and ask the installer whether they'll mount over more than one. Many won't.

Structural requirements are set locally, usually drawing on International Code Council model codes. Some jurisdictions require a structural engineer's letter for older homes. Sistering rafters typically costs from a few hundred to a few thousand dollars, depending on how much framing needs work. Finding that before panels are up is far cheaper than finding it after.

If the house is decades old, ask the roofer whether any old roofing or underlayment should be tested for asbestos before tear-off. For homes built before 1978, use a contractor trained in lead-safe work practices.

How Should Solar Mounts Be Flashed on Old Shingles?

Each mount should have metal flashing slid under the shingle course above it, with lag screws driven into a rafter, not just the decking. Every mount is a hole in the roof, and how it's sealed decides whether you get a dry attic or a ceiling stain.

Roof flashing is the real defense against leaks. Sealant is the backup. Mounts held down mainly with caulk are a red flag, because caulk degrades long before a 25-year warranty runs out.

Old shingles make this harder. They turn brittle, and lifting a tab to slide flashing under it can crack it. Ask how the crew handles damaged shingles around mounts. Ask whether your shingle manufacturer's warranty allows third-party penetrations, and whether the installer follows manufacturer and National Roofing Contractors Association guidance on flashing details.

What Does a Solar Detach and Reset Cost?

A detach and reset typically runs roughly $2,000 to $6,000 for an average home system, and you pay it on top of the roof itself. Panel count, roof pitch, how much electrical work the crew must redo, and local labor rates drive the range.

Here's how the paths compare for an asphalt roof and a system of about 20 panels:

ScenarioTypical extra costWhat drives it
Replace roof, then install solar$0 for resetYou pay for the roof once, before panels go up
Install solar, replace roof laterRoughly $2,000 to $6,000 for resetPanel count, roof pitch, electrician time, permits
Asphalt roof replacement aloneRoughly $8,000 to $20,000Roof size, layers to remove, decking repairs, region

Other costs hide behind the headline numbers: weeks of lost production while the system is down, permit fees (reset work and roof replacement often both need permits, depending on your jurisdiction), and decking repairs found during tear-off. Budget for all of it.

Should You Replace the Roof First or Install Solar First?

Replace the roof first if it has fewer than about 15 years left, and install solar first only if the roof is young enough to outlast most of the system's life. A roof under 10 years old and in good shape can usually take panels without trouble.

If the roof falls in between, have your solar installer and a roofer quote together. Some installers have roofing partners who can schedule the tear-off and panel install back to back, which saves a second round of mobilization. Compare the all-in price against the solar-only price.

Whichever path you take, the contract should state the roof condition on the install date, who handles leaks at the mounts, and the reset price if a roofer needs the panels off. If the roof is a poor candidate altogether, a ground array may be worth pricing, and the DOE Solar Energy Technologies Office has general background on solar system options.

Your next step: book an independent roof inspection this month, then hand the report to every installer who quotes you.

Questions people ask

How old is too old for a roof to get solar panels?

There's no single cutoff, since condition matters as much as age. As a rough guide, three-tab roofs past 10 to 12 years and architectural roofs past 15 to 18 years deserve a hard look from an independent roofer before you sign.

Can solar panels damage asphalt shingles?

The panels themselves usually don't, but mounting hardware can if it's poorly flashed or installed on brittle shingles. Cracked tabs and unsealed lag screw holes are the usual causes of leaks.

Who pays if my roof leaks after solar installation?

It depends on the cause and the paperwork. If a leak traces to an installer's mount, their workmanship warranty should cover it. If the shingles simply wore out, that's generally on you, so read the terms before you sign.

Can a roofer remove and reinstall the panels?

Often the solar company handles the detach and reset, because the system has to be shut down and rewired safely. A roofer may coordinate the schedule, but a licensed electrician or the installer should do the electrical disconnect and reconnection.

Do I need a permit to detach and reset solar panels?

Usually yes, though it varies by city and county. Call your local building department before work starts, and ask whether the reset needs its own electrical permit and inspection.

Sources and further reading

Elsewhere in Remodeling