Fix and Furrow
Advertise

Part of our Home Repair Troubleshooting guide

Why Do Dresser Drawers Stick? Fixes for Each Cause

Humid-season sticking, one-sided binding, and gritty runners each point to a different cause. Here's how to tell them apart.

Save to Pinterest

We may earn a commission when you buy through links on this page. It never changes what we recommend. Learn more

Wooden dresser with one drawer pulled open showing the runners and drawer sides
Photo: Julian Hochgesang on Unsplash

The short answer

Dresser drawers usually stick because the wood swells in humid weather, the runners are dirty or dry, the case is out of square, or the runners are worn. Seasonal sticking points to humidity, one-sided sticking to racking or an uneven floor, and gritty movement to grime. Most DIY fixes cost $60 or less.

Typical cost
$0 to $60 for most DIY fixes; $100 to $400 typical for professional furniture repair
Time needed
15 minutes to one afternoon
Skill level
Beginner

Key points

  • The pattern of sticking (seasonal, one-sided, gritty, or worsening over years) points to the likely cause faster than taking the drawer apart.
  • Clean runners and paraffin wax often fix a sticking drawer in about 15 minutes for almost no money.
  • Don't plane a drawer that's swollen in summer, or it may rattle loose when the air dries out in winter.
  • A drawer that sticks on one side usually means the case is out of square or the dresser is sitting on an uneven floor.
  • Loose joints, a visibly racked case, or a drawer front pulling away call for a furniture repair pro, not more wax.
In this guide
  1. Why do dresser drawers stick? Start with the pattern
  2. Does humidity make wooden drawers stick?
  3. How do you clean and wax drawer runners?
  4. Why does a drawer stick on one side?
  5. When are runners or glides worn out?
  6. How do you plane or sand a rubbing edge safely?
  7. When should you call a furniture repair pro?

Look at when and where the drawer sticks before you grab a plane. The pattern is the fastest diagnostic you have, and it keeps you from shaving wood off a drawer that only needed wax.

Why do dresser drawers stick? Start with the pattern

Dresser drawers stick mainly because of swollen wood, dirty runners, an out-of-square case, worn runners, or loosening joints, and the timing and location of the problem tell you which to check first.

What you noticeMost likely causeCheck first
Sticks in summer, loosens in winterSwollen woodRoom humidity, shiny rub marks
Gritty, scratchy, or sluggish feelDirt or old wax on runnersRunner surfaces and the track
Sticks on one side onlyOut-of-square case or uneven floorLevel, diagonal measurements
Catches only when fully open or closedWorn or bent runners and glidesGrooves, bends, missing stops
Gets slowly worse over yearsLoosening joints or wearWobble in the drawer box or case

Work from the top down. The first causes are the most common and the cheapest to fix.

Does humidity make wooden drawers stick?

Yes. Solid wood absorbs moisture and swells across the grain, so a drawer that sticks in humid weather and frees up in winter is almost always swollen.

To confirm, pull the drawer and look at the sides. Shiny, burnished strips mean the wood is rubbing the case. If the drawer slides fine in January, you have your answer.

A small hygrometer, usually $10 to $20, tells you what the room is doing. Indoor relative humidity of roughly 30 to 50 percent is the commonly recommended range. If the room sits well above that, run a dehumidifier (ENERGY STAR-certified models use less power) and give the wood a week or two to shrink back before you touch it with a tool.

If the wood on the drawer bottom or sides is bare, a thin coat of finish slows moisture exchange. It won't stop it, but it helps.

How do you clean and wax drawer runners?

Remove the drawer, wipe the runners and tracks clean, then rub paraffin wax on every surface where wood touches wood. It's the best first fix for most dressers, and we'd try it before anything else.

  1. Empty the drawer and lift it out. Most lift up and pull straight out; if it stops, look for a stop block at the rear.
  2. Vacuum the case interior, including the rails and the bottom of the frame.
  3. Rub gummy or dark residue with a rag dampened with mineral spirits. Let it dry fully.
  4. Rub a plain paraffin candle or canning wax block along the runner tops, the drawer's bottom edges, and the track grooves.
  5. Slide the drawer in and out five or six times to spread the wax, then wipe off any flakes.

Skip oily sprays and silicone sprays on wood. They soak in, can stain, and silicone can cause trouble if you refinish the piece later.

Why does a drawer stick on one side?

A drawer that sticks on one side usually points to an out-of-square case or an uneven floor, not a problem with the drawer itself.

Start with the floor. Set a level on top of the dresser, in both directions. If the bubble is off, shim under the short foot with a hardwood wedge or a furniture pad and test again. Plenty of cases are fixed right here.

If the floor isn't the culprit, empty the drawers and check the corners of an empty opening with a carpenter's square. Then measure the opening diagonally, corner to corner, both ways. A difference of more than about 1/8 inch suggests the case has racked. Snugging loose back-panel and frame screws can sometimes nudge a mildly racked case back. If it takes force, stop and see the section on professionals below.

When are runners or glides worn out?

Runners and glides are worn when you see flat, polished dips in the wood, bent metal rails, or missing nylon pieces, and the drawer catches at the same spot every time.

Older dressers often have wooden runners that wear a groove over decades. Glue a strip of hardwood into the worn spot with wood glue, clamp it with a couple of bar clamps, and let it cure overnight. Then sand it flush and wax.

Bent metal drawer slides can sometimes be straightened with pliers, but replacing them is usually easier. A pair of side-mount slides typically runs $10 to $40, depending on length and weight rating. Stick-on nylon drawer glides are a cheaper fix for worn wood and usually cost $5 to $15 for a pack. Match the slide length to your drawer depth, and expect to drill new pilot holes.

How do you plane or sand a rubbing edge safely?

Find the rubbing spot by its shine, then take off thin passes with a block plane or 120-grit sandpaper, testing the fit after each one.

Rub a pencil along the burnished area so the graphite shows where wood touches. Plane with the grain, a few shavings at a time, and keep the edge square. Remove less than you think you need. You can't put wood back.

Wear safety glasses and a dust mask. Painted furniture made before 1978 may contain lead paint, so test it with a home kit before sanding. If the test is positive, don't sand, and bring in a lead-safe professional. When you're done, seal the bare wood with a matching finish or wax so it doesn't swell again.

Plywood and particleboard that swelled from water damage usually won't shrink back, so planing won't cure it. Replacing the drawer or the piece may be the more realistic option.

When should you call a furniture repair pro?

Call a furniture repair pro when joints are loose, the case is visibly racked, or the drawer box is coming apart, because wax and planing won't fix a structural problem.

Warning signs include open dovetails, a drawer front that pulls away from its sides, a case that wobbles when you push the top, and diagonals that differ by well over 1/8 inch. Antiques and heirlooms also deserve a professional, since the wrong glue or finish can cut their value. Repair shops typically charge $100 to $400 for drawer work, depending on your region, how many drawers are involved, and how much joinery needs rebuilding.

Your next step: pull the worst drawer today, look for the shiny rub marks, and match them to the table above before you choose between wax, shims, or a phone call.

Questions people ask

Can I use soap or beeswax instead of paraffin?

Dry bar soap and plain beeswax both work as drawer lubricants on bare wood. Avoid anything scented, dyed, or oily, since those can stain the wood or leave a sticky film.

Why does my drawer stick only when it's almost closed?

That usually points to a swollen front edge, a rubbing corner at the back of the case, or a drawer stop that's out of position. Look for burnish marks near the front corners and the rear of the runners.

Can I fix a stuck drawer without pulling it out?

Sometimes. If you can open it a few inches, you can wax the visible edges and rails, but don't spray anything into the track. If it won't move, don't force it, because forcing can split a joint or crack a runner.

Will a dehumidifier stop my drawers from sticking?

It often helps if humidity is the cause, since drier air lets the wood shrink back over a week or two. It won't help with a racked case or worn runners.

How long should waxed runners stay smooth?

A thin coat typically lasts months to a year, depending on use and humidity. If you need to re-wax every few weeks, there's probably another cause such as swelling or misalignment.

Sources and further reading

Elsewhere in Decorating