Fix and Furrow
Advertise

Fall Lawn Fertilizer Application Rate: How Much and When

A bag labeled winterizer means little until you do the math: pounds of nitrogen, a soil-temperature window, and when to skip.

Save to Pinterest

We may earn a commission when you buy through links on this page. It never changes what we recommend. Learn more

Broadcast spreader on a green lawn with fallen leaves in autumn
Photo: Engin Yapici on Unsplash

The short answer

For cool-season grass, apply 0.75 to 1 pound of actual nitrogen per 1,000 square feet in early fall, and optionally the same again in late fall while the grass is still green but growth has slowed. Divide the pounds of nitrogen you want by the bag's nitrogen percentage to get pounds of product to spread.

Typical cost
$15 to $70 per bag covering about 5,000 sq ft; soil test often $10 to $30
Time needed
1 to 2 hours per feeding for an average lawn
Skill level
Beginner

Key points

  • Cool-season lawns generally get 0.75 to 1 pound of actual nitrogen per 1,000 square feet per fall feeding, and rarely more than 1 pound of quick-release nitrogen at once.
  • Pounds of product equal pounds of nitrogen wanted divided by the bag's first number as a decimal, so a 24-0-12 bag needs about 4.2 pounds per 1,000 square feet for 1 pound of nitrogen.
  • The window runs from late August until shortly before the ground freezes, and the late feeding should follow cooling soil and slowing top growth, not a calendar date.
  • An established lawn often doesn't need phosphorus, and a soil test, often $10 to $30 through a state lab, tells you for sure.
  • Skip or delay fertilizing drought-stressed turf, frozen ground, an already overfed lawn, and warm-season grass late in the year.
In this guide
  1. Why is fall the best time to feed cool-season grass?
  2. How do you read a fertilizer bag and calculate pounds per 1,000 square feet?
  3. How much nitrogen should you apply in fall?
  4. When should you apply fall fertilizer before frost?
  5. Is slow-release or quick-release nitrogen better in fall?
  6. Does your lawn need phosphorus or potassium in fall?
  7. When should you skip fertilizing in fall?

The number that matters on a fertilizer bag is the first one. A 24-0-12 bag is 24 percent nitrogen, so spreading about 4.2 pounds of it over 1,000 square feet puts down 1 pound of actual nitrogen, the usual ceiling for a single fall feeding on cool-season turf. The rest is getting the math right and picking the right week.

Why is fall the best time to feed cool-season grass?

Fall is the best time because cool-season grasses such as Kentucky bluegrass, tall fescue and perennial ryegrass put their energy into roots and stored carbohydrates once summer heat breaks. Air temperatures drop while the soil is still warm, so roots keep growing even as the blades slow down. Nitrogen applied then feeds roots instead of pushing a flush of leaves you'll just mow.

That stored energy pays off in spring. The lawn greens up from reserves, so you don't need a heavy spring dose of nitrogen, which can invite disease and weak growth. Fall feeding also helps thin areas fill in after the summer slump, and thicker turf crowds out weeds.

Warm-season grasses like bermudagrass, zoysia and centipede are different. They go dormant with cool weather, so a late winterizer does little for them, and their last feeding generally belongs in early fall, well ahead of frost. Check your USDA hardiness zone and your local extension office to see which camp your lawn is in.

How do you read a fertilizer bag and calculate pounds per 1,000 square feet?

Read the three numbers as the percentages of nitrogen, phosphate and potash by weight, then divide the pounds of nitrogen you want by the nitrogen percentage as a decimal. The result is the pounds of product to spread on each 1,000 square feet.

The formula: pounds of product = pounds of nitrogen wanted ÷ nitrogen percentage (as a decimal). Here it is for two common targets:

Bag analysisNitrogenProduct per 1,000 sq ft for 1 lb NProduct per 1,000 sq ft for 0.75 lb N
46-0-0 (urea)46%2.2 lb1.6 lb
32-0-1032%3.1 lb2.3 lb
24-0-1224%4.2 lb3.1 lb
18-24-1218%5.6 lb4.2 lb
10-10-1010%10 lb7.5 lb

Measure the lawn first. Multiply length by width for each rectangular section, add the sections together, and subtract the house, driveway and beds. Guessing is how people end up spreading double.

How much nitrogen should you apply in fall?

Apply 0.75 to 1 pound of actual nitrogen per 1,000 square feet per feeding, which is where most extension guidance lands for cool-season lawns. Over a full year, bluegrass and fescue typically total roughly 2 to 4 pounds, depending on species, whether you leave clippings, and how dense you want the turf.

For the most common situation, a bluegrass or fescue lawn in the northern half of the country, we'd pick two feedings: about 1 pound in early to mid September, and another 0.75 to 1 pound in late fall. The second is what people mean by winterizer fertilizer. If you only do one, make it September, when roots are most active. Skip the late one if the lawn is already thick and dark green.

Treat the label rate as a limit, not a suggestion. Quick-release nitrogen above about 1 pound per 1,000 square feet in one pass risks burn and wasted nitrogen. Some slow-release products allow more per application, but the label governs. Many states and cities also cap nitrogen per application and per year, and some set a no-fertilizing date. Check local rules before you buy.

Calibrate your spreader too. A drop spreader or broadcast spreader set by the number printed on the bag is only an estimate. Set it a bit low and make two passes at right angles so skips don't show.

When should you apply fall fertilizer before frost?

Apply the first feeding between late August and late September, and the late feeding after top growth slows but while the grass is still green, before the ground freezes. Soil temperature is a better guide than the date.

Early feeding works while the soil is warm and daytime air temperatures run in the 60s to 70s. For the late feeding, a soil thermometer pushed 2 to 4 inches down should read roughly 50 degrees Fahrenheit and falling. Mowing is slowing, you may have had a light frost or two, and the blades are still green. In much of the northern U.S. that lands between late October and mid-November, though it shifts with your climate and the year.

Don't apply to frozen or snow-covered ground. Granules sit on the surface, and meltwater carries them toward storm drains. If you missed the early feeding, you can still do one now at the lower end of the rate, as long as the lawn is still growing.

Is slow-release or quick-release nitrogen better in fall?

Slow-release nitrogen is the safer pick for most homeowners, because it feeds over several weeks and is less likely to burn grass or leach away. Quick-release nitrogen works faster and usually costs less per bag, but it demands a precise rate and good timing.

TypeHow it feedsTypical cost per 5,000 sq ft bagMain risk
Quick-release nitrogen (urea, ammonium sulfate)Days to a couple of weeksAbout $15 to $35Burn and runoff if overapplied
Slow-release nitrogen (polymer-coated urea, sulfur-coated, methylene urea)Several weeks to a couple of months, depending on product and temperatureAbout $30 to $70Slower response in cold soil

Price moves with brand, the share of nitrogen that is slow-release, and whether the bag adds weed control or iron. Most store-brand fall blends mix both types, and the footnote on nitrogen sources tells you the split. For the September feeding, we'd choose slow-release nitrogen or a blend with a meaningful slow-release share. Coated products release slowly in cold soil, so some turf guides favor a plain quick-release nitrogen source for the late feeding. Your extension office can tell you what suits your grass.

Does your lawn need phosphorus or potassium in fall?

An established lawn usually doesn't need phosphorus in fall, and a soil test is the only way to know. Many soils already hold enough, and a number of states restrict phosphorus on lawns unless a test shows a need or you're seeding.

Potassium sometimes earns its place because it helps with stress tolerance, but that depends on your soil too. Order a test through your county's Cooperative Extension office. Lab tests often run $10 to $30 depending on the state, and they report phosphorus, potassium and pH with a recommendation. A store-bought soil test kit is rougher, but it can flag an obvious problem.

If your test shows plenty of phosphorus, buy a bag with a zero in the middle position. Seeding is the exception. New grass wants starter fertilizer with phosphorus, unless a soil test says your soil is already high.

When should you skip fertilizing in fall?

Skip or delay when the lawn is drought-stressed, already overfed, frozen or snow-covered, or warm-season grass heading dormant. In each case the nitrogen can't be used, so it burns the turf or ends up somewhere you don't want it.

  • Drought stress: Brown, dormant turf isn't taking up nitrogen. Water for a couple of weeks first, then feed once it's growing again.
  • Already overfed: A dark green, fast-growing lawn with heavy thatch after a big summer program is a candidate for a soil test, not another bag.
  • Frozen ground or snow cover: Nothing soaks in, and runoff takes it.
  • Warm-season grass in late fall: Heading into dormancy, it can't use the nitrogen, and a late push can hurt cold hardiness.
  • Weed-and-feed products: These contain herbicide, which can harm new seed and the roots of trees and shrubs under the lawn. Wear gloves, follow the label on pets and kids, and call the National Pesticide Information Center with questions about the active ingredients.

Your next step: measure the lawn, check the nitrogen percentage on the bag you have, and calculate the pounds before you load the spreader. Water in about a quarter inch afterward unless the label says otherwise, and wrap up feeding before you winterize your sprinkler system.

Questions people ask

Is it too late to fertilize my lawn in November?

Not if the grass is still green and the ground isn't frozen. A late feeding at 0.75 to 1 pound of nitrogen per 1,000 square feet still gets stored for spring. Check local rules, since some areas set a cutoff date.

Should I water after spreading fall fertilizer?

Usually, yes. About a quarter inch moves granules off the blades and into the soil, which reduces burn and runoff. Check the label first, because some products say to hold off watering for a period.

Can I fertilize and overseed on the same day?

Yes, as long as you use a starter fertilizer made for new grass. Avoid weed-and-feed and crabgrass preventer products, since their herbicides can stop seed from sprouting.

Can I use leftover spring fertilizer in fall?

Only if the analysis suits fall and you've done the math. Spring bags often include crabgrass preventer, which can interfere with seeding. Read the label before you spread.

What happens if I put on too much nitrogen?

You can burn the grass, leaving yellow or brown stripes, and push excess growth that invites disease. Extra nitrogen can also wash into storm drains. Water the area well if you overapplied, and skip the next feeding.

Sources and further reading

Elsewhere in Gardening