Winterize Water Service Line: A Month-by-Month Checklist
Your October-to-March schedule, with the line between your pipes and the utility's, plus what changes in Sun Belt states.
Save to PinterestWe may earn a commission when you buy through links on this page. It never changes what we recommend. Learn more
The short answer
Start in October, before the first hard freeze: find and test your main shutoff, drain hose bibs, and blow out irrigation. In November, insulate exposed pipes and check the meter pit. From December through February, drip a faucet when lows hit the low 20s°F. In March, restart slowly and inspect. The utility usually owns the curb stop.
- Typical cost
- $20 to $150 in DIY supplies; $75 to $200 for a professional sprinkler blowout
- Time needed
- About 2 to 4 hours in October, 1 to 2 hours in November
- Skill level
- Beginner
Key points
- Call your utility in October to confirm who owns the meter, meter pit, curb stop, and the line to your house.
- Drain hose bibs and blow out sprinkler lines before nights reliably drop to 32°F, not after.
- Insulation slows freezing but does not stop it, so pair it with a faucet drip during cold snaps.
- Never open a meter pit or turn a curb stop yourself unless the utility says you may.
- Sun Belt homes see fewer freezes but are less prepared for them, so keep a one-night freeze plan ready.
In this guide
- Why do water service lines freeze, and which parts do you own?
- October: Locate Your Shutoffs and Drain Outdoor Lines
- November: Insulate the Meter Pit, Crawl Space, and Exposed Runs
- How do you prevent freezing from December through February?
- How does winterizing differ in cold and warm climates?
- When should you blow out sprinkler lines in your region?
- March: Post-Winter Checks and Restarting Systems
This is general information, not financial, insurance or legal advice. Rates, rules and programs vary by state and change often, so confirm details with the provider or a licensed professional.
Before you buy a single foam sleeve, find out where your responsibility starts. Call your water utility in October and ask who owns the meter, the meter pit, the curb stop, and the line between the curb and your house. The answer decides which tasks below are yours.
Why do water service lines freeze, and which parts do you own?
Service lines freeze when cold reaches the pipe, either because the line is shallower than the frost depth or because it passes through unheated space such as a crawl space, garage wall, or basement corner. In most systems the utility owns the main in the street and the curb stop, and often the meter and meter pit. You typically own the line from the curb stop or meter to the house, plus every pipe inside. Ownership varies by utility, so confirm it.
Frost depth runs from a few inches along the Gulf Coast to four feet or more in the northern tier, and your local building department can tell you the design depth for your area. Lines buried below it rarely freeze. The trouble spots are where the pipe rises: the foundation entry, the meter setting, and any exposed run.
October: Locate Your Shutoffs and Drain Outdoor Lines
In October, find your main shutoff valve, test it, and drain every outdoor line before the first hard freeze. The valve is usually where the line enters the house, often in a basement, utility room, or crawl space. Close it fully, then reopen it. A quarter-turn ball valve should move easily. An old gate valve that is stiff, weeps at the stem, or won't fully close is a job for a plumber, and you want to learn that now rather than during a burst.
Then handle the outdoors. Disconnect every hose, close the interior shutoff to each hose bib if one exists, and open the outdoor spigot to drain. A frost-free hose bib still needs the hose removed. A connected hose traps water, keeps the stem from draining, and can split the pipe inside the wall where you can't see it.
Leave the curb stop alone. If you plan to shut the house down for the whole winter, ask the utility to close it and drain the line. Tag your interior valve so anyone in the house can find it in a hurry.
November: Insulate the Meter Pit, Crawl Space, and Exposed Runs
November is for insulating anything that sits in cold air: exposed pipes, the entry point, and the area around the meter. Use foam pipe insulation sized to the pipe, tape the seams, and wrap elbows and valves. Seal gaps in the rim joist and around pipe penetrations, where cold air blows straight onto the line. If your crawl space has operable vents, closing them for winter is common in cold climates, but follow local guidance for your foundation type.
Insulation slows heat loss. It does not create heat, so a pipe in a truly cold space can still freeze. For most homes we'd pick foam insulation plus a faucet drip over heat tape, because it has no wiring to fail. Where a pipe can't be protected any other way, heat tape is an option, but use only listed products, follow the instructions exactly, plug into a GFCI outlet, and never overlap the tape. Call an electrician if you need a new circuit.
To protect your water meter from freezing, start by knowing where it sits. An indoor meter needs a warm room, so keep the meter closet door open or the basement above freezing. For meter pit insulation, the utility usually installs and maintains it. If the lid is cracked or tilted, or the insulation has sunk, report it. Don't stuff in your own material, since it can block a radio-read antenna or interfere with the meter.
How do you prevent freezing from December through February?
From December through February, keep water moving through the line and warm air around the pipes whenever a cold snap hits. When overnight lows are forecast in the low 20s°F or below for several hours, open the tap farthest from the entry to a pencil-width stream. Moving water resists freezing, and an open tap relieves pressure if ice forms. The extra water costs little next to a burst.
Open cabinet doors on exterior walls so room heat reaches the pipes. If you're away, keep the thermostat at 55°F or higher, and know how your homeowners policy treats freeze damage. Some insurers set conditions for vacant or unoccupied homes, and rules vary by state and provider. See our homeowners insurance maintenance checklist by season for what to ask.
If a faucet stops flowing, leave it open and warm the pipe with a hair dryer, working from the faucet toward the frozen spot. Never use an open flame. If the freeze is underground or at the meter, call the utility or a plumber. If a pipe has burst, close the main shutoff valve first, then call for help.
How does winterizing differ in cold and warm climates?
Cold climates drive the schedule with frost depth and meter pits, while Sun Belt homes focus on irrigation, scale-stuck valves, and the occasional hard freeze. The table shows where the priorities split.
| Task | Cold north | Warm Sun Belt |
|---|---|---|
| Main risk | Frozen service line, meter, and pit | Rare hard freeze hitting unprotected pipes |
| Start date | October | November, with a forecast watch |
| Hose bibs | Drain and shut off indoors | Insulated covers, drain on freeze nights |
| Irrigation | Full sprinkler blowout | Shut off supply, protect above-ground parts |
| Faucet drip trigger | Lows in the low 20s°F | Lows in the mid-20s°F or below, since pipes are less protected |
| Extra concern | Heaved or damaged pit lids | Scale-seized shutoff valves |
In parts of the South and Southwest, hard water scale can lock a shutoff valve in place, and you discover it only when you need it. Exercise each valve once in the fall. Warm-region homes also tend to run pipes through attics and exterior walls and leave an irrigation backflow preventer standing above ground. Cover it with an insulated bag made for the purpose, not sealed plastic that traps moisture. Some municipalities require a certified tester for backflow devices, so check before you disturb one.
When should you blow out sprinkler lines in your region?
Blow out sprinkler lines before the ground freezes: typically October in the northern states, late October to mid-November in the middle of the country, and in the Deep South often not at all. Time it by your first reliable run of nights near 32°F, not by the calendar. Southern systems generally need only a supply shutoff and protection for exposed parts when a freeze is forecast.
A sprinkler blowout uses an air compressor to push water out of the lines, zone by zone. Stay within your system's rated pressure, because too much can crack heads and fittings. Wear safety glasses and never stand over a sprinkler head while it's pressurized. Unless you already own a compressor with a regulator, we'd hire it out. A professional blowout usually runs $75 to $200 depending on zones and region, which is fair money for a job with expensive failure modes. For smarter irrigation settings in spring, see EPA WaterSense.
March: Post-Winter Checks and Restarting Systems
In March, check for winter damage before you restore full pressure: open valves slowly, then inspect pipes, hose bibs, the meter, and irrigation. Follow this order:
- Look at the meter and pit for standing water, a heaved lid, or cracks, and report problems to the utility.
- Open the main shutoff valve slowly and listen for hissing or hammering.
- With every fixture off, watch the meter. If it moves, use our guide to finding the leak when the meter runs.
- Open each outdoor bib with a hose attached and check the wall or basement side for drips.
- Restart irrigation one zone at a time and check heads, valves, and the backflow preventer.
- Write down anything that failed or nearly did, and fix it before October.
Next step: call your utility this week to confirm who owns what, and put an October reminder on your calendar.
Questions people ask
Should I shut off the water if I'm leaving for the winter?
For a long absence, closing the main shutoff and draining the lines is the safest approach, but only if your heating and any fire sprinkler system allow it. Keep some heat on, around 55°F, and ask your insurer what it requires for unoccupied homes.
How can I tell if my service line is frozen?
The usual sign is no water, or only a trickle, at every fixture while the main shutoff is open and neighbors still have service. If only a fixture on an exterior wall is affected, the freeze is probably in the house piping. A suspected freeze underground or at the meter is a call to the utility or a plumber.
Who pays if the line freezes between the meter and the house?
That stretch is usually the homeowner's responsibility, though ownership varies by utility. Check your homeowners policy for freeze and service line provisions, and ask the insurer directly, since coverage differs by state and provider.
Can I put heat tape on a buried service line?
Not unless the product is rated for that use and installed to its instructions. Buried lines are best left to a plumber or the utility, since wiring and heating a buried pipe carry electrical and code risks.
How cold does it have to get before pipes freeze?
Pipes in unheated spaces can begin freezing when air stays around 20°F for several hours, and sooner with wind or no insulation. Buried lines depend on frost depth, soil, and snow cover, so your local building department or utility can give a better answer.
Sources and further reading
- EPA WaterSense Irrigation efficiency guidance for spring restart and sprinkler settings
- National Association of Insurance Commissioners Consumer information on homeowners insurance and state regulators
Was this article helpful?