Fix and Furrow
Advertise

How to Winterize a Built-In Gas Grill and Outdoor Kitchen

Gas valve, sink trap, ice maker line, and cabinet vents each need a different fix, and the order you do them in matters.

Save to Pinterest

We may earn a commission when you buy through links on this page. It never changes what we recommend. Learn more

Built-in gas grill and outdoor kitchen island with a fitted cover and a dusting of early snow
Photo: Justin Jones on Unsplash

The short answer

To winterize a built-in gas grill, close the gas shutoff valve and burn off the fuel left in the line, clean and dry the burners and grates, then drain and blow out the sink, ice maker, and water lines with an air compressor at about 30 to 40 psi. Finish with a breathable cover and open cabinet vents.

Typical cost
$20 to $150 in supplies; roughly $100 to $400 per visit if you hire a pro for gas or plumbing work
Time needed
2 to 4 hours
Skill level
Intermediate

Key points

  • Close the gas shutoff valve first, then run a burner until the flame dies so the line is empty before you turn the knobs off.
  • Water left in a sink trap, faucet, or low-point valve is what splits fittings, so drain the lines, blow them out at low pressure, and empty or treat the trap.
  • Never seal a gas cabinet airtight; leave the vents open and use a breathable cover plus a desiccant tub.
  • Capping, cutting, or modifying a gas pipe belongs to a licensed gas fitter, not a homeowner with a wrench.
  • Do the work on a dry afternoon while overnight lows are still above 32°F, not the night the freeze warning hits.
In this guide
  1. What tools and materials do you need?
  2. How do you find the gas and water shutoffs?
  3. How do you shut off the gas and burn off leftover fuel?
  4. How do you drain the outdoor sink, ice maker, and water lines?
  5. How do you clean and prep the grill and burners?
  6. How do you cover the grill without trapping moisture?
  7. What winterizing mistakes cause spring repairs?
  8. When should you call a licensed gas or plumbing pro?

Three jobs protect a built-in grill kitchen through winter: close the gas valve and burn off what's left in the line, get every drop of water out of the sink, ice maker, and supply lines, and cover the grill in a way that lets the cabinet breathe. Everything else is cleanup. Pick a dry afternoon while overnight lows are still above 32°F, because you'll be working with a compressor and wet fittings, not frozen ones.

What tools and materials do you need?

You need basic hand tools, an air compressor with a regulator, and propylene glycol antifreeze, the two items people tend to forget.

  • Soapy water in a spray bottle for leak checks
  • Adjustable wrench and channel-lock pliers for fittings and the trap
  • Air compressor with a pressure regulator and a blow-out adapter that fits a hose-thread connection
  • 1 to 2 gallons of propylene glycol antifreeze, the non-toxic kind sold for RV and potable plumbing
  • Wire grill brush, putty knife, shop vacuum, and mild dish soap
  • Stainless steel cleaner and microfiber cloths
  • High-smoke-point cooking oil for cast iron grates
  • Desiccant moisture absorber tubs for the cabinet
  • A breathable grill cover sized to your grill head
  • Bucket, towels, flashlight, work gloves, and safety glasses

Supplies run roughly $20 to $150, depending mostly on whether you already own a compressor and what a fitted cover costs.

How do you find the gas and water shutoffs?

A natural gas built-in usually has a quarter-turn shutoff valve inside the cabinet or in a flush box near the grill, a propane built-in shuts off at the tank valve, and water shutoffs are typically inside the house, in a crawlspace, or in a valve box near the sink run.

A natural gas shutoff valve is normally fed by a hard pipe from the house or a yard line. On most ball valves, a handle parallel to the pipe means open and a handle crossways means closed. A propane built-in typically has a tank in the cabinet with a regulator and hose. Check the water side separately, since it rarely sits near the gas.

ComponentWinter actionDIY or pro
Gas shutoff valve (natural gas)Close it, handle crossways to the pipeDIY
Quick-disconnect hoseDisconnect and cap the fitting if it has a capDIY
Hard-piped gas lineLeave valve closed; cap or alter only if neededLicensed pro
Propane tankClose valve, disconnect, keep upright and outdoorsDIY
Sink supply and drainShut off, drain, blow out, treat trapDIY; pro for buried lines
Ice maker or fridgeUnplug, drain, clean, prop door openDIY
Hardwired outlets or circuitsTurn off at the breakerElectrician for any changes

If you can't find a shutoff, or one won't turn, stop there and call a pro.

How do you shut off the gas and burn off leftover fuel?

Close the gas shutoff valve first, then run a burner until the flame dies so the fuel trapped between the valve and the burners is used up.

If you want to burn residue off the grates, do that before these steps, with the valve still open.

  1. Open the lid and make sure all burner knobs are off.
  2. Close the gas shutoff valve at the grill or at the supply.
  3. Turn one burner to high and try to light it. The flame will sputter and go out as the line empties. Repeat for the side burner or rotisserie burner if you have one.
  4. Turn every knob to off. A knob left open means gas flows the moment you reopen the valve in spring.
  5. If your grill uses a quick-disconnect hose, detach it and cap the fitting if a cap came with it. Leave a hard-piped line closed and intact.
  6. For propane, close the tank valve and disconnect the regulator. Keep the tank upright and outdoors, away from the house and any ignition source, and never store it in a garage, shed, or basement.

The NFPA and the U.S. Consumer Product Safety Commission both publish grill and propane safety guidance worth a quick read.

Save the leak check for spring: brush soapy water on each joint after you reopen the valve and watch for growing bubbles.

How do you drain the outdoor sink, ice maker, and water lines?

Shut off the water supply, open the faucet and any low-point drain valve, blow the lines out with air, and deal with the trap.

  1. Shut off the supply. Use the interior shutoff or the dedicated valve for the outdoor kitchen. Check whether it also feeds a hose bib, since many do.
  2. Open everything. Open the faucet to both hot and cold, then open any low-point drain valve or cap. Let it run until it stops.
  3. Disconnect supply hoses at the faucet and tip them to drain, including braided lines under the sink.
  4. Blow out the lines. Attach the compressor through the blow-out adapter, set the regulator to about 30 to 40 psi, and push air through each line with the faucet open until only air comes out, no mist. Stay under 50 psi unless your faucet or pipe maker says otherwise, because high pressure can damage cartridges and fittings. Wear safety glasses and keep your face away from the faucet outlet.
  5. Deal with the trap. We'd empty it: unscrew the P-trap and let it drain. If you can't remove it, pour a cup or two of propylene glycol antifreeze down the drain so it sits in the trap. Never use automotive antifreeze, which is ethylene glycol and toxic.
  6. Service the ice maker or fridge. Empty it, unplug it, disconnect and drain the water inlet line, wipe it dry, and prop the door open a few inches. Check the manual, since some outdoor-rated units tolerate cold better than others.

How do you clean and prep the grill and burners?

Clean grease and food residue off every surface now, because leftover grease feeds pests and holds moisture all winter.

Pull the grates and any flame tamers or heat plates. Scrape them, wash with mild dish soap, rinse, and dry fully. Wipe cast iron grates with a thin coat of high-smoke-point oil so they don't rust. Empty the grease tray, vacuum the firebox, and use a putty knife on the baked-on layer.

Then look at the burners. Brush the ports and check the burner tubes for spider webs and insect nests, which can block gas flow and cause flare-ups at startup. Inspect any hose for cracks or brittle spots and replace it now rather than in May.

Wipe stainless surfaces with the grain using stainless steel cleaner, and pull the batteries from igniters. Close the lid only after everything is completely dry.

How do you cover the grill without trapping moisture?

Use a breathable grill cover and leave the cabinet vents open, since trapped moisture does more damage over a winter than snow does.

Enclosed gas grill cabinets generally need ventilation openings by design, and blocking them is a bad habit even with the gas off. Your grill manual and local code set the details. If rodents are a worry, screen the vents with quarter-inch hardware cloth rather than closing them. Clear out paper goods, pet food, charcoal, and anything else a mouse would move into. Set one or two desiccant moisture absorber tubs in each cabinet bay and check them midwinter.

Skip the vinyl tarp or the plastic sheet taped down tight. Plastic holds condensation against stainless steel and stone, and a damp cover over a damp grill is how you get mildew. Strap the cover so wind can't peel it back, and brush heavy snow off the countertop and grill head.

What winterizing mistakes cause spring repairs?

The most expensive mistakes are leaving water in a trap or low-point line, using the wrong antifreeze, and sealing a gas cabinet airtight.

Turning off only the knobs is the common one. The valve is your real shutoff. Blowing out lines at full compressor pressure is next, because many compressor tanks run well above 100 psi without a regulator. Shutting off the wrong water valve is quieter: if it also feeds a hose bib or a house line, you'll find out when someone needs water. Food left in the cabinet invites rodents by December, and propane stored indoors is a fire risk.

Tag the gas and water valves with the date and what you did, so spring startup goes in the right order.

When should you call a licensed gas or plumbing pro?

Call a licensed pro if you can't find a shutoff, smell gas, or need to cut, cap, or modify any pipe.

Gas piping work generally requires a licensed gas fitter and often a permit, and local code decides the details. Call one if the shutoff valve won't turn fully or weeps when you test it, if the line is corroded or kinked, or if you want the stub capped rather than just valved off. A service call typically runs about $150 to $400, depending on your area and whether a permit is involved.

On the water side, call a plumber if there's no shutoff or drain valve, if the supply runs underground or inside a wall, or if a line has frozen before. A winterization visit often costs roughly $100 to $300. A licensed electrician should handle hardwired outlets, circuits, or anything that looks scorched or damaged.

Your next step: pick a dry day this week, print the table above, and work through it top to bottom. Come spring, reopen the gas valve slowly, soap-test every joint, and flush the water lines before you use the sink.

Questions people ask

When should I winterize my outdoor kitchen?

Do it before overnight temperatures drop to 32°F, ideally with a few days of margin. In much of the U.S. that means October or November, but your local first-frost date decides it.

Do I need to disconnect a natural gas line to the grill for winter?

Usually not. Closing the shutoff valve and turning all knobs off is typically enough for a hard-piped line, though your grill manual and local code have the final word. Only a licensed gas fitter should cap or remove piping, while a quick-disconnect hose can simply be detached.

Can I leave a propane tank in the grill cabinet over winter?

If the cabinet was designed to hold the tank, the grill manual decides what the maker allows. Either way, close the valve, and never move the tank into a garage, basement, or shed. Safety guidance is to keep cylinders upright and away from the house.

Is it safe to leave food in an outdoor refrigerator through winter?

Empty it. Food in a unit that swings between cold and warm won't stay reliably cold, and USDA guidance is to keep refrigerated perishables at 40°F or below. A clean, unplugged fridge with the door propped open also avoids mildew.

Do I need to cover a stone or masonry grill island?

Cover the grill head and any exposed stainless steel. For the masonry itself, follow the stone or sealer maker's guidance, and keep runoff from soaking the base. Brush off heavy snow so it doesn't pile against the cabinet doors.

Sources and further reading

Elsewhere in Outdoor Living