Fix and Furrow
Advertise

Part of our Home Repair Troubleshooting guide

Pipe Burst From Freezing? What to Do in the First Hour

A timed walkthrough: the right shutoff, safe power, a temporary fix, photos for your claim, and who to phone in what order.

Save to Pinterest

We may earn a commission when you buy through links on this page. It never changes what we recommend. Learn more

Icicles hanging from a rusty pipe outlet against a stone wall
Photo: Nadiia Ganzhyi on Unsplash

The short answer

Shut off the main water valve immediately, then open the lowest faucet to drain the lines. If water is near outlets, the panel, or light fixtures, cut power only if you can reach the breakers dry; otherwise stay out and call an electrician. Contain the leak with a temporary clamp, photograph everything before cleanup, then call your insurer and a plumber.

Typical cost
Temporary repair parts roughly $10 to $50; a plumber visit often $200 to $800; drying and remediation commonly $1,000 to $5,000 or more
Time needed
About one hour for the emergency steps; repairs and drying take days
Skill level
Beginner

Key points

  • Close the main water shutoff first, before you hunt for the split, and drain the lines by opening the lowest faucet.
  • Treat wet outlets, fixtures, and panels as live; never wade through water to reach a breaker, and keep power off until an electrician clears it.
  • A clamp or push-fit coupling is a temporary stop, not a repair, and the rest of the frozen run may have splits you haven't found yet.
  • Shoot video and photos of everything wet before you move, mop, or discard anything, and keep every receipt.
  • Call a licensed plumber to fix the source, your insurer the same day, and a remediation company if more than a small area is soaked.
In this guide
  1. What do you need on hand for the first hour?
  2. How do you shut off the water after a burst pipe?
  3. Is it safe to touch anything electrical after a burst pipe?
  4. How do you stop the flow and limit the spread?
  5. How do you document burst pipe damage for an insurance claim?
  6. Who should you call for a burst pipe, and in what order?
  7. What mistakes make the damage and the claim worse?
  8. What if the burst pipe is in a wall or ceiling?

Close the main water shutoff before you do anything else. A split supply line keeps pushing water into the house for as long as the valve stays open, and every other decision gets easier once the flow stops. The order below is the one that limits damage: water off, power safe, leak contained, damage documented, then the phone calls.

What do you need on hand for the first hour?

You need a flashlight, something to catch water, and a few basic tools, plus repair parts that are worth buying before the next freeze.

  • Flashlight or headlamp, since shutoffs live in dark corners and the power may be off
  • Adjustable pliers, and a meter key or long-handled pliers if your shutoff is at the street
  • Buckets, old towels, and a mop
  • A pipe repair clamp sized to your pipe (1/2 inch and 3/4 inch are common for supply lines)
  • A tubing cutter for copper or a PEX cutter for PEX, plus a push-fit coupling for the same pipe type
  • Self-fusing silicone tape, for pinhole leaks only
  • A wet/dry vac, used only where you know the power situation is safe

How do you shut off the water after a burst pipe?

Turn the main shutoff a quarter turn if it has a lever, or clockwise if it has a round wheel, until it stops.

  1. Find where the water line enters the house. In cold climates that's usually a basement wall, crawlspace, utility room, or garage, often near the water heater. In warmer regions the shutoff may sit in an outdoor meter box.
  2. Read the handle. A lever (ball valve) is closed when the handle sits perpendicular to the pipe. A wheel (gate valve) closes clockwise; turn it firmly but gently, since old ones seize or snap. A handle that spins freely points to a broken stem.
  3. Go to the street if the inside valve fails. The meter box usually has a valve on your side of the meter. If your utility allows homeowners to operate it, use a meter key or long-handled pliers on that valve only. If it won't turn, or you're unsure, call the water utility's emergency line rather than forcing it.
  4. Drain the lines. Open the lowest faucet in the house (a basement sink or tub) and the highest one, then flush a toilet. That relieves pressure and pulls water away from the break.
  5. Deal with the water heater. For gas, turn the control to pilot or off. For electric, switch the breaker off, but read the next section first and don't reach a wet panel. Heating elements that run in a partly drained tank can burn out.

Don't count on the small stop valves under sinks and toilets. They isolate one fixture and do nothing for a split in the line behind it.

Is it safe to touch anything electrical after a burst pipe?

No, treat every wet outlet, switch, light fixture, and breaker panel as live until a licensed electrician says otherwise.

If standing water reaches outlets, power strips, appliances, or the panel, stay out of the room. If the panel is dry and you can reach it without crossing wet floor, switch off the breakers for the affected rooms, or the main breaker if you can't tell which circuits are involved. Water coming through a ceiling fixture or fan is as much an electrical problem as a plumbing one, so turn that circuit off before anyone walks beneath it.

Sparking, buzzing, a burning smell, or a wet panel means you leave and call 911 or your electric utility's emergency line, then a licensed electrician.

Keep the affected circuits off until the area is dry and a licensed electrician has checked any outlets, switches, and wiring that got wet. The U.S. Consumer Product Safety Commission publishes home electrical safety information if you want to read more.

How do you stop the flow and limit the spread?

Once the main is closed, cap the split temporarily and contain the water that's already out.

  1. Take 60 seconds of video first. Walk the wet area before you move anything. The documentation section below covers what to capture.
  2. Contain it. Put buckets under drips, push towels against doorways, and lift rugs, electronics, and boxes off wet floors. Set furniture legs on foil or plastic blocks so they don't stain the floor.
  3. Drain a bulging ceiling only if conditions are right. If power to that area is off and you can stand to the side, poke one small hole at the lowest point of the bulge with a screwdriver and let it drain into a bucket. A ceiling holding that much water can fail without warning, so if you're unsure, leave the room and call a pro.
  4. Make a temporary fix on an exposed pipe. Once the line is drained, a pipe repair clamp over a split buys you time. For a longer split, cut out the damaged section with a tubing cutter and bridge the gap with a push-fit coupling. Self-fusing silicone tape is a short-term patch for pinholes only. Local code may limit where push-fit fittings can go, such as inside walls, so treat every one of these fixes as temporary until a plumber looks.
  5. Restore water slowly, if you do. If you turn the main back on before the plumber arrives, open it a little at a time and watch every joint and the full frozen run for about ten minutes. Ice that melts later can reveal more splits.
  6. Keep the pipes warm. Raise the thermostat and open cabinet doors on exterior walls. Never thaw with a torch or open flame, which can ignite framing and damage fittings.

Use a wet/dry vac only on a circuit you know is dry, and never in deep standing water. When in doubt, stick with buckets and towels.

How do you document burst pipe damage for an insurance claim?

Photograph and video everything wet before you clean, move, or throw anything out, because that record anchors your claim.

Film a slow walkthrough of each affected room, narrating the date, time, and what you see, then take close-ups of water lines on walls, ceiling stains, wet flooring, and damaged belongings. Photograph the split pipe and the shutoff you closed, and keep the damaged pipe section in a bag.

Start an item list with a description, rough age, and replacement cost for each damaged item, plus model and serial numbers for electronics. Save receipts for emergency work, rented pumps or dryers, and hotel stays, and keep a call log with names, times, and your claim number. Most policies expect you to take reasonable steps to prevent further damage, and those costs are often reimbursable, though that depends on your policy.

Don't discard damaged goods until the adjuster has seen them or approved it, unless something is a hazard. Photograph that first.

Coverage generally hinges on whether the water release was sudden and accidental. Slow, long-term leaks and damage in a house left unheated can be treated differently, so read your policy or ask your agent. Compare your deductible, which can run from a few hundred dollars to a couple thousand, against the repair estimate before you decide how to proceed.

Who should you call for a burst pipe, and in what order?

Call a licensed plumber to fix the source and your insurer the same day, add a water remediation company if more than a small area got wet, and start with 911, the utility, or an electrician if the power looks unsafe.

WhoCall whenWhat they'll need from you
911, utility, or licensed electricianSparks, a wet panel, or water in outletsWhere the water is and which breakers are off
Licensed plumberAny burst, even after a temporary fixPipe material, location of the split, shutoff status, photos
InsurerSame day, as soon as it's safePolicy number, date and cause, photos, your list of steps taken
Water remediation companySoaked drywall, insulation, or carpet, or water sitting more than a dayPhotos, access to the rooms, your claim number

In a hard freeze, plumbers get slammed, so ask for an arrival window. An accessible repair often costs $200 to $800, and opening walls or repiping runs higher. Repiping or opening walls may also need a permit, so ask the plumber who pulls it. Remediation for a room or two, with a dehumidifier and air movers, commonly runs from about $1,000 to several thousand dollars. Both depend on your region and how much has to be opened up. If water is surfacing in the yard, the break is probably in the buried line, and anyone digging needs to call 811 first.

For the usual situation we'd get the plumber on the way first, call the insurer while you wait, then bring in remediation. Drying can't finish while a pipe is still leaking, and many policies let you choose your own contractor, so check yours. Be wary of anyone who knocks on your door after a freeze and wants a signed contract on the spot.

What mistakes make the damage and the claim worse?

The costliest mistakes are delay, wet electrical work, and cleaning before documenting.

Don't flip the power back on to 'test' things; water in a wall cavity or outlet box can energize more than you can see. Don't thaw with a torch, which is a fire risk and can create new splits. And don't let wet materials sit. Mold can begin to grow within 24 to 48 hours in wet drywall and insulation, so start drying right away.

Hold off on sanding or scraping old surfaces. Homes built before 1978 may have lead paint, so read the EPA's lead guidance first. Older textured ceilings, joint compound, and pipe wrap can contain asbestos, so have suspect material tested before any demolition.

Finally, don't call the temporary fix permanent. A clamp behind a cabinet can fail later, and damage from a known, unrepaired split may complicate a second claim.

What if the burst pipe is in a wall or ceiling?

If the burst is behind a wall or above a ceiling, keep the main closed, make the power safe, and let a plumber open it rather than cutting in yourself.

Signs include a stain spreading on drywall, a bulge, the sound of running water, peeling paint, or a water meter that keeps moving when every fixture is off. Close the main, then check the meter. A dial still turning after the lines drain points to a leak you can't see.

Turn off the circuits for any lights or outlets in that wall or ceiling, and stay out from under a sagging section. Don't cut into a wall to hunt for the pipe, because wiring and other supply lines often run beside it. A plumber can use a moisture meter or thermal camera to find the split and limit how much gets opened.

Remediation crews usually cut wet drywall back past the visible water line so the cavity can dry, so photograph the wall and ceiling before they start. Until repairs are done you'll need bottled water and a plan for toilets, and your insurer may cover temporary living costs if the house is unlivable, depending on the policy.

Your next step, once things are dry and repaired: write down which pipes froze, add insulation or heat there, and put frozen-pipe prep on next fall's to-do list. The Department of Energy's Energy Saver site has guidance on insulating pipes and winterizing your home.

Questions people ask

How long can I wait before water damage gets serious?

Damage begins as soon as water reaches drywall, insulation, and flooring, and it spreads the longer it sits. Aim to have a plumber on the way and drying started the same day.

Should I leave faucets dripping for the rest of the freeze?

Yes, a slow drip on faucets served by pipes in exterior walls or unheated spaces helps keep water moving. Also open cabinet doors under sinks and keep the thermostat steady, even at night.

What if a pipe is frozen but hasn't burst yet?

Open the nearest faucet, then warm the pipe slowly with a hair dryer or heating pad, starting at the faucet end. If you can't find the frozen section or you see bulging or cracking, shut off the main and call a plumber.

Can I stay in the house after a burst pipe?

Only if you have safe electrical power, heat, and a way to handle drinking water and toilets. If any of those are missing, ask your insurer about temporary living expenses before you book a hotel.

Do I need a permit to repair a burst pipe?

Replacing a short section of existing pipe often doesn't, but repiping runs or opening walls may. Rules vary by city and county, so ask your plumber or local building department.

Sources and further reading

Elsewhere in Home Improvement